IMPORTANT INFORMATION

Please read and understand this entire manual before attempting to assemble, operate or install the product. If you have any question regarding the product, please call customer service at 1-877-888-8225,

9 a.m.-5 p.m., EST, Monday-Friday.

When using electrical appliances, always follow basic precautions to reduce the risk of fire, electrical shock, and injury to persons including the following:

1. Read all instructions before using this appliance.

2. This appliance is hot when in use. To avoid burns, do not touch hot surfaces with bare skin.

If provided, use handles when moving this appliance. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes and curtains at least 3 ft. from the front of this appliance.

WARNING: In order to avoid overheating, do not cover the heater.

WARNING: Use extreme caution when operating heater near children and the disabled.

3. The appliance is not to be used by children or persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction.

4. This appliance is not a toy. Supervise children playing near it.

5. If possible, always unplug this appliance when not in use.

6. Do not operate any heater with a damaged cord or plug, after the appliance malfunctions, or if it has been dropped or damaged in any manner.

7. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.

8. Only a qualified service person should repair this product.

9. Under no circumstances should this fireplace be modified. Parts having to be removed for servicing must be replaced prior to operating this fireplace again.

10. Do not use outdoors.

11. This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never locate this appliance where it may fall into a bathtub or other water container.

12. Do not run cord under carpeting. Do not cover cord with throw rugs, runners or the like. Arrange cord away from traffic areas and where it will not be tripped over.

13. To disconnect this appliance, turn controls to the off position, and then remove plug from outlet.

14. Connect to properly grounded outlets only.

15. This appliance, when installed, must be electrically grounded in accordance with local codes or, in the absence of local codes, with the current CSA C22.1 Canadian Electrical Code or for U.S.A. installations, follow local codes and the National Electrical Code, ANSI/NFPA NO.70.

16. The heater must not be located immediately below a socket-outlet.

17. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the appliance.

18. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces, like a bed, where opening may become blocked.

19. This appliance has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint or flammable liquids are used or stored. This fireplace should not be used as a drying rack for clothing. Do not hang Christmas stockings or other decorations on or near this product.

20. Use this appliance only as described in the manual. Any other use not recommended by the manufacturer may cause fire, electric shock or injury to persons.

21. There is a thermostat limiter inside the heater. When the inner temperature overheating or abnormal

heating occurs, the thermostat protective device will cutoff the power supply to avoid damage to the

fireplace or risk of fire.

3

IMPORTANT INFORMATION

22. Avoid the use of an extension cord because the extension cord may overheat and cause risk of fire.

However, if you have to use an extension cord, the cord must be No.14 AWG minimum size and rated not less than 1875 watts. The extension cord must be a three-wire cord with grounding type plug and cord connection. The extension cord shall not be more than 20 ft. in length.

23. See directions in Figure 1. This heater is for use on 120 volts. The cord has a plug as shown in figure

1. See Figure 1 for grounding instruction. An adapter as shown at C is available for connecting three-

blade grounding type plugs to two-slot receptacles. The green grounding plug extending from the

adapter must be connected to a permanent ground such as a properly gounnded outlet box. The

adapter should not be used if a three-slot grounded receptacle is available.

Grounding Pin

Cover Of Grounded

Outlet Box

A B

C D

Metal

Screws

Adapter

Grounding

Means

Grounding

Pin

SAVE THESE

INSTRUCTIONS

Fig. 1

4