- No category
advertisement
8.6 Startup overview required optional
X
X
X
X
Overview
8.7 configuration (basic settings of the device)
8.8 registration of wireless sensors WS Pt 100
8.9 alarm parametrization
8.10 relay test
X
X
8.11
8.12 sensor simulation
RS485 Modbus interface
X 8.13 code lock
8.7 Configuration
The appropriate program must be selected in accordance with the settings of the wireless sensors (see operating instructions for WS Pt 100 wireless sensors). This is done once during commissioning.
switch of control voltage at the WR250
keep «Set» key pressed and switch on control voltage again
after 10 s, 8 Pr 5 8 is shown in the display
release «Set» key
select program in accordance with the wireless sensors, using the «Up»/«Down» keys
(program # see operating instructions for WS Pt 100 wireless sensor)
press «Set» key
device goes through reset and starts
8.8 Registration of wireless sensors
Start in Display mode (return to Display mode by pressing «Set» key for ≥ 2s). After 30 s without input, the device will also return to Display mode.
press «Down» key
display 8 S 1 .
8 / 8 off .
8 (sensor 1 / off) flashes alternatingly
press «Set» key
press «Down» key («Up» key turns off the sensor input port)
display 8 on .
8 (on)
press «Set» key
display 8 adr .
8 / 8 lrn .
8 (address / learn) flashes alternatingly
within 30 s, briefly (approx. 1 s) link contacts 3 and 4 of the sensor plug-in socket at the WS Pt 100 wireless sensor (small wire jumper, or if the sensor plug is plugged in, briefly link the two contacts 3 and 4)
registration OK: Display 8 lrnd.
8 (learned) will flash 4×
registration error: Display 8 Err .
8 (error) will flash 4×
display 8 S 2 .
8 / 8 off .
8 (sensor 2 / off) flashes alternatingly
register sensors 2 to 6 (optional)
after sensor 6, change to next menu item (parametrization of alarms) datum / name ) : 13.05.2011 Sc
Page 9 of 20
Z. Nr.: 12200-0702-02
Type: WR250
ZIEHL industrie-elektronik GmbH + Co KG, Daimlerstr.13, D-74523 Schwäbisch Hall, Tel.: +49 791 504-0, Fax: -56, e-mail: [email protected]
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 3 Application and brief description
- 3 Function overview
- 3 Connection diagram
- 4 Display and control elements
- 5 Important information
- 6 Installation
- 6 Detailed description
- 7 Starting the wireless system
- 7 General notes on operation
- 7 Display mode
- 7 Menu mode
- 7 Parametrization mode
- 8 Operating flowchart
- 9 Startup overview
- 9 Configuration
- 9 Registration of wireless sensors
- 10 Alarm parametrization
- 11 Short-circuit monitoring
- 11 Relay test
- 12 RS485 Modbus interface
- 12 Sensor Simulation
- 13 Code lock
- 13 Notes on operation
- 14 Possible values in the display
- 16 Factory default settings
- 17 Servicing and maintenance
- 17 Troubleshooting
- 18 Displaying the software version
- 18 Technical data
- 20 Design V