advertisement
3.3 Relays regimes
Regime m = 1 (parameter 3111 and 3121)
Action
Evaluation of correct internal code from the buttons
Note
According to setting
Day/Night
According to setting
Day/Night
Parameter
3211-3215
3311-3315
3411-3415
321*
331*
341*
Relay
Internal code from the phone
Option to choose 1 or 2 digits of code
2 digit code is basic and it is possible to shorten it by using * in the first place of code during programming
351
361
Regime m = 4
Action
Press buttons
Note
Any number of button other than in 311*
Parameter
3114
Relay
Button set in 311* 3114
Regime m = 6
Action
Press of the button
Note
Any number of button other than in 311*
Parameter
3116
Note
Button set in 311* or 312* 3116 t1 – time of connection of relay 1 (parameter 371) t2 – time between impulses of relay 1 (parameter 301)
Tab. 1 Table of relay controls
Relay
-
3.4 Person in the building
The person in the building means the person who is in telephone contact with the Brave entry system (i.e. Mr Smith).
3.4.1 Outbound call
An outbound call is a call from the Brave system (i.e. started by a visitor).
Once the system has been dialled, a phone inside of the building rings and on pick up it is possible to talk to the visitor at the door. By choosing a code it is possible to switch on a relay (parameter 35) if it is set in mode m=1, switch over the Day/Night regime (parameter 45, 46) and disconnect the connection
(parameter 43). 10sec before the end of the call (parameter 52) the system
BRAVE SlimDP – User and service manual 21
advertisement
Related manuals
advertisement
Table of contents
- 6 BASIC FEATURES
- 9 INSTALLATION
- 9 Name card panel
- 9 Uncover control elements
- 10 Wiring and wall mounting
- 12 Switches
- 13 Voice level
- 15 Covering control elements
- 15 Replacing name card panel
- 17 (COSW)
- 18 Time Relay
- 18 Power supply 12V AC
- 18 Power supply 12V DC
- 18 USB Programming cable
- 19 DOOR ENTRY SYSTEM OPERATION
- 21 Outbound call
- 22 Incoming call
- 22 Door Entry System with keyboard – module SlimKey
- 23 PARAMETER PROGRAMMING
- 23 Entry into the programming
- 23 Parameter programming
- 25 DESCRIPTION OF PROGRAMMABLE PARAMETERS