advertisement
Brake Lever
1
2
General Information
Right Handlebar Switches
1
2 ccmh cggq
1. Brake lever
2. Adjusting screw
To adjust the brake lever, push the lever forward and turn the adjusting screw in to increase the distance or out to shorten the distance from the handlebar.
Warning
Do not attempt to adjust the levers with the motorcycle in motion as this may lead to loss of motorcycle control and an accident.
After adjusting the levers, operate the motorcycle in an area free from traffic to gain familiarity with the new lever setting.
Do not loan your motorcycle to anyone as they may change the lever setting from the one you are familiar with causing loss of control or an accident.
1. Engine stop switch
2. Starter button
Engine Stop Switch
In addition to the ignition switch being turned to the ON position, the engine stop switch must be in the RUN position for the motorcycle to operate.
The engine stop switch is for emergency use.
If an emergency arises which requires the engine to be stopped, move the engine stop switch to the STOP position.
Note:
• Although the engine stop switch stops the engine, it does not turn off all the electrical circuits and may cause difficulty in restarting the engine due to a discharged battery. Ordinarily, only the ignition switch should be used to stop the engine.
43
advertisement
Related manuals
advertisement
Table of contents
- 20 Instrument Panel Layout
- 21 Speedometer and Odometer
- 21 Tachometer
- 21 Trip Computer
- 22 Odometer/Trip Meter
- 22 Trip Meter
- 23 Trip Meter Reset
- 23 Odometer
- 23 Clock Adjustment
- 24 Changing Units (Imperial, US or Metric)
- 26 ABS Disable (models with ABS only)
- 26 Service Interval Indicator
- 27 Gear Change Lights
- 27 Gear Change Light Modes
- 27 Setting Gear Change Light Limits
- 28 Changing the Set Speed
- 29 Setting Gear Change Lights to Off
- 30 Lap Timer
- 31 Data Recording Mode
- 31 New Lap Recording
- 32 Data Retrieval Mode
- 33 Coolant Temperature Gauge
- 34 Fuel Gauge
- 34 Tyre Pressure Monitoring System (TPMS)
- 34 Function
- 35 Tyre Pressure Sensor Serial Number
- 35 Front Sensor
- 35 Rear Sensor
- 35 System Display
- 36 Sensor Batteries
- 36 Tyre Pressures
- 36 Replacement Tyres
- 37 Warning Lights
- 37 Direction Indicators
- 37 High Beam
- 37 Low Fuel
- 37 Neutral
- 37 Low Oil Pressure Warning Light
- 37 High Coolant Temperature Warning Light
- 38 Engine Management System Malfunction Indicator Light
- 38 Alarm/Immobiliser Indicator Light
- 39 Tyre Pressure Warning Light
- 40 Ignition Key
- 41 Ignition Switch/Steering Lock
- 41 Engine Immobiliser
- 41 Ignition Switch Positions
- 42 Brake and Clutch Lever Adjusters
- 42 Clutch Lever
- 43 Brake Lever
- 43 Right Handlebar Switches
- 43 Engine Stop Switch
- 44 Starter Button
- 44 Left Handlebar Switches
- 44 Headlight Dip Switch
- 45 Direction Indicator Switch
- 45 Horn Button
- 45 Pass Button
- 45 Fuel Requirement/Refuelling
- 45 Fuel Grade
- 46 Fuel Tank Cap
- 47 Filling the Fuel Tank
- 48 Stand
- 48 Side Stand
- 48 Tool Kit and Handbook
- 49 Seat Lock
- 49 Seat Care
- 51 Running-In
- 52 Safe Operation
- 52 Daily Safety Checks
- 56 To Stop the Engine
- 56 To Start the Engine
- 57 Moving Off
- 58 Changing Gears
- 59 Braking
- 61 ABS (Anti-Lock Brake System) models only
- 62 Parking
- 63 Considerations for High-Speed Operation
- 64 General
- 64 Steering
- 64 Luggage
- 64 Brakes
- 64 Tyres
- 65 Engine Oil
- 65 Coolant
- 65 Electrical Equipment
- 65 Miscellaneous
- 74 Scheduled Maintenance
- 77 Engine Oil
- 78 Oil Level Inspection
- 79 Oil and Oil Filter Change
- 80 Disposal of Used Engine Oil and Oil Filters
- 80 Oil Specification and Grade
- 81 Cooling System
- 81 Corrosion Inhibitors
- 82 Coolant Level Inspection
- 82 Coolant Level Adjustment
- 83 Coolant Change
- 83 Radiator and Hoses
- 84 Fuel Tank
- 84 Raising
- 85 Lowering
- 85 Throttle Control
- 86 Inspection
- 88 Clutch
- 89 Inspection
- 89 Adjustment
- 89 Drive Chain
- 90 Chain Lubrication
- 90 Chain Free-Movement Inspection
- 91 Chain Free-Movement Adjustment
- 92 Chain and Sprocket Wear Inspection
- 93 Brakes
- 93 Brake Wear Inspection
- 93 Breaking-in New Brake Pads and Discs
- 94 Brake Pad Wear Compensation
- 94 Disc Brake Fluid
- 95 Brake Fluid Level Inspection and Adjustment
- 96 Brake Light Switches
- 96 Steering/Wheel Bearings
- 96 Steering Inspection
- 97 Inspecting the Steering (Headstock) Bearings for Free Play
- 97 Wheel Bearings Inspection
- 98 Front Suspension
- 98 Front Fork Inspection
- 99 Suspension Setting Chart - Speed Triple
- 99 Suspension Setting Chart - Speed Triple R
- 100 Front Suspension Settings
- 101 Rebound Damping Adjustment
- 102 Compression Damping Adjustment
- 103 Rear Suspension Adjustment
- 103 Rebound Damping Adjustment
- 104 Compression Damping Adjustment
- 106 Tyres
- 106 Tyre Inflation Pressures
- 107 Tyre Wear
- 107 Minimum Recommended Tread Depth
- 108 Tyre Replacement
- 111 Battery
- 111 Battery Removal
- 112 Battery Disposal
- 112 Battery Maintenance
- 112 Battery Discharge
- 112 Battery Discharge During Storage and Infrequent Use of the Motorcycle
- 113 Battery Charging
- 113 Battery Installation
- 114 Fuse Boxes
- 114 Fuse Identification
- 116 Headlights
- 117 Headlight Bulb Replacement
- 119 Rear Light
- 119 Rear Light Replacement
- 119 Direction Indicator Lights
- 119 Bulb Replacement
- 120 Licence Plate Light
- 120 Bulb Replacement
- 121 Cleaning
- 121 Preparation for Washing
- 121 Where to be Careful
- 122 After Washing
- 122 Seat Care
- 122 Unpainted Aluminium Items
- 123 Cleaning of the Exhaust System
- 123 Washing
- 123 Drying
- 123 Protecting