b) Installation. Renkforce RF100 v2

b) Installation

• Install the file “Cura_15.04.6.exe“ (for Windows ®

“Software” from the SD card.

) or “Cura-15.04.6-MacOS.dmg“ (for Mac OS) from the directory

• Follow the on-screen instructions during the installation process. For details, refer to instructions provided on https://ultimaker.com/.

c) Setup of the Software - Windows

®

Connect to the 3D printer

• Connect the 3D printer to a free USB port on your computer with the help of the supplied USB cable. Switch the printer on.

When the printer is connected to the computer, ensure the printer remains switched on at all times.

• When connecting printer and computer for the first time, the operating system recognizes the new hardware and searches for suitable drivers.

If a suitable driver is not available, you can manually install the necessary drivers. Do the following:

1 Open PC device Manager.

A new device is recognized under “Other devices” (or Ports

COM & LPT).

2 Right click on the “USB Serial Port”, and then select

“Update Driver Software...”.

3 Click on “Browse my computer for driver software.”

The required driver is available on the SD card “Software/ ft232 usb uart driver”.

4 Follow the on-screen instructions to finalize the updating process.

28

Start the software

After installation, the “Configuration Wizard“, which will guide you through the set up process of the 3D printer, appears:

1

1 Select your preferred language (e.g. English).

2 Click “Next >”.

2

29

3 Select “Other”.

4 Click “Next >”.

3

4

5 Select “Custom...“

6 Click “Next >”.

30

5

6

7 Input parameters as shown.

8 Click “Finish” to complete the wizard.

7

8

31