TransNav Graphical User Interface Reference

Map View

Any IP-based management connection can provide the communication path between the Node-level GUI and the Traverse system’s active GCM, including front-access craft

Ethernet, Backplane Ethernet, DCC, and ECC.

Note: The Node-level GUI works only with Traverse nodes in this release. TE-100 and TE-206 nodes are not supported. The information in the Node-level GUI application is obtained directly from the Traverse platform. The Node-level GUI release must match the corresponding Traverse release.

For information on the Node-level GUI features, see Node GUI Menus.

The tabs on the Map View allow you to view and change the following information.

Note: Map View is available on the EMS GUI only.

• Alarms: Alarms on nodes in the domain. See the Operations and Maintenance

Guide, Chapter 2—“Managing Alarms.”

• Events: Events on nodes in the domain. See the Operations and Maintenance

Guide, Chapter 3—“Managing Events.”

• Config: Configuration information for the selected piece of equipment.

• Protection: Define protected rings. See the TransNav Management System

Provisioning Guide, Chapter 2—“Protection Group Configuration.”

• Performance: Monitor performance and VT/TU capacity data. See the Operations and Maintenance Guide, Chapter 1—“Managing Performance.”

• Service: Define services between nodes in a domain. See the TransNav

Management System Provisioning Guide, Chapter 1—“Service Provisioning

Concepts.”

• Service Group: Configure a number of services into groups on the node. See the

TransNav Management System Provisioning Guide, Chapter 4—“Service

Groups.”

2 Chapter 1 General Description of GUI Features TN6.0.x