Lap Belt Installation. Britax B-Safe Gen2 FlexFit, B-Safe Gen2 FlexFit Plus

BRITAX Child Safety, Ltd.

Lap Belt Installation

IMPORTANT: Check your vehicle owner’s manual to determine how to lock your vehicle belt system.

1. Secure your child in the infant car seat before installing the car seat in the vehicle.

2. Place the infant car seat rear facing on the vehicle seat.

3. Pull the vehicle belt out and route it through the carrier only belt guides.

4. Verify that the vehicle belt is not twisted and then buckle. Lock your vehicle seat belt system as instructed by your vehicle owner’s manual.

26

B-SAFE GEN2 FLEXFIT & FLEXFIT PLUS User Guide

5. Push the infant car seat firmly into the vehicle seat while removing all slack from the vehicle belt.

Carrier Only Installation with Lap Belt

CHECKLIST

ü Check that the vehicle belt is tight, not twisted, and that the infant car seat is secure. The infant car seat is secure when it moves less than 2.5 cm (1 inch) front-to-back or side-to-side at the vehicle belt path.

ü Check that the recline angle is correct. The proper recline angle is achieved when the level line on the shell is level to the ground.

ü Check that the infant car seat handle is rotated and locked into position 1. See page 35.

27