Electrical installation. CDA RV 700

Electrical installation

For your safety please read the following information:

WARNING!

Before effecting any intervention on the electrical parts the appliance must be disconnected from the network.

IMPORTANT: The cooker must be installed in accordance with the manufacturer’s instructions.

Incorrect installation, for which the manufacturer accepts no responsibility, may cause damage to persons, animals and things.

General

– Connection to the mains must be carried out by qualified personnel in accordance with current regulations.

– The appliance must be connected to the mains checking that the voltage corresponds to the value given in the rating plate and that the electrical cable sections can withstand the load specified on the plate.

– The appliance can be connected directly to the mains placing an omnipolar switch with minimum opening between the contacts of 3 mm between the appliance and the mains.

– The power supply cable must not touch the hot parts and must be positioned so that it does not exceed 75°C at any point.

– Once the appliance has been installed, the switch must always be accessible.

– If the power supply cable is damaged it must be substituted by a suitable cable.

N.B. For connection to the mains, do not use adapters, reducers or branching devices as they can cause overheating and burning.

If the installation requires alterations to the domestic electrical system call an expert.

He should also check that the electrical system is suitable for the power absorbed by the appliance.

IMPORTANT: this cooker must be connected to a suitable double pole control unit adjacent to the cooker.

No diversity can be applied to this control unit.

The connection of the appliance to earth is mandatory.

The manufacturer declines all responsability for any inconvenience resulting from the inobservance of this condition.

44

Electrical feeder cable connection

To connect the feeder cable to the cooker it is necessary to:

– Remove the 2 screws that hold shield

A behind the cooker.

– Open completely the cable clamp D.

– Insert the feeder cable into the cable save P. The supply cable must be of a suitable size for the current requirements of the appliance; see the section “Feeder cable section”.

– Connect the phase and earth cables to terminal B according to figures 45 and 46.

– Pull the feeder cable and block it with the cable clamp D.

– Re-mount shield A.

N.B. The earth conductor must be left about 3 cm longer than the others.

Feeder cable section type H05RRF

230 V 3 x 2,5 mm

2

(**)

(**) – Connection with wall box connection.

230 V

L

1

N

(L

2

)

PE

PE Earth

N Neutral

L Live

Fig. 46

B

D

P

A

Fig. 45

45