Installing the Thermostat. Hunter 42711-01, 44260

Y

12

inSTalling ThE ThErMoSTaT

inSTalling ThE Wall plaTE

1. Remove the wall plate from the new thermostat by pressing the release tab on the bottom of the thermostat.

2. Position the new wall plate on the wall and pull the labeled wires through the opening.

3. If the existing holes do not match those on the Hunter wall plate, or if there are no existing holes, visually level the wall plate and mark the wall for two holes.

13

Y

14

inSTalling ThE ThErMoSTaT, ConT.

4. Remove the wall plate and drill two 3/16” holes where marked.

5. Tap the plastic anchors into the holes until they are flush with the wall.

6. Reposition the wall plate on the wall, pulling the wires through the opening. Insert the mounting screws through the wall plate and into the anchors. Verify that the wall plate is visually level and securely tighten both screws.

15