PELLET STOVES USER MANUAL

INSTALLING COMFORT MAXI/ COMFORT PLUS

The insert is supplied with a sliding metal base that allows it to be installed in a pre-existing flue.

The sliding base allows the easy extraction of the insert both for feeding pellets into the feed-box and for any maintenance or cleaning at the end of the season. If there is no pre-existing flue, it can be built using the insert support pedestal (optional kit); in fact, the latter attaches the insert to the floor.

Components description:

A. Primary air intake pipe

B. Flue exhaust pipe

C. Adaptation frame

C

B

B

F

C

D. Sliding base and rails

E. Plug for power socket

F. Ducting pipe

A

A

E

D

COMFORT PLUS

D

COMFORT MAXI

ASSEMBLy wITh SLIDING BASE

Take the sliding base and position it in the pre-existing flue. Use chalk to mark the blocking holes of the base on the flue surface.

Drill 8 mm holes for the steel expansion inserts.

Make a hole measuring 60 mm in line with the air intake.

Remember the power socket on the rear of the insert so that the plug is accessible once installation is completed.

Fix the base using the clamping screws.

Create a flue exhaust and socket connection respecting the points described previously.

Take the insert, tilt it so that the wheels fit into the relative rails, make it run until the flue gas insert is completely inserted into the flue gas conveyor box.

18 ENGLISH