- No category
advertisement
6.3.2 Power Management demo program
TREK V3 VPM Sample Code is demonstration of vehicle power management (VPM).
System Menu
TREK V3 VPM Sample Code as below figure
1. Common page
47 TREK-570/303 User Manual
2. Low Battery Protection & Ignition Control page
3. Backup Battery Information page
4. Alarm Wakeup Control page
Common page
VPM Common page as below figure
1. Library Version
2. Firmware Version
3. Car Battery Mode (Decide LBP what voltage mode to use)
4. Current Battery Voltage
5. Ignition Status
6. Mode Control
7. Wakeup Source Control
Low Battery Protection & Ignition Control page
TREK-570/303 User Manual 48
VPM Low Battery Protection & Ignition Control page as below figure
1. Low Battery Protection Control
2. Ignition Control
Backup Battery Information page
VPM Common page as below figure
49 TREK-570/303 User Manual
Alarm Wakeup Control page
VPM Common page as below figure
1. Alarm wakeup Status Control
2. RTC Timer Control
3. Alarm Wakeup Time Control
Testing VPM
1.
Opening "TREK_V3_Sample_Code_VPM.exe"
2.
You should see the firmware version and voltage below figure
TREK-570/303 User Manual 50
advertisement
Related manuals
advertisement
Table of contents
- 12 Introduction
- 13 General Specifications
- 15 Dimensions
- 15 Figure 1.1 TREK-570 dimensions
- 18 A Quick Tour of the TREK-570 Computing Box
- 18 Figure 2.1 Front view of TREK
- 18 Figure 2.2 Rear view of TREK
- 18 Installation Procedures
- 18 Connecting the Power Cord
- 18 Table 2.1: Pin Definition of Power Cord
- 19 Power Connector (12/24V; 9 ~ 32V)
- 19 Figure 2.3 Power connector outlook
- 19 Table 2.2: Power Connector
- 19 Running the BIOS Setup Program
- 22 Overview of Hardware Installation & Upgrading
- 22 Installing the Storage Device and Memory
- 22 Installing Optional Accessories
- 22 Installing TREK-570 Peripheral Modules
- 22 Figure 3.1 Install peripheral in the system
- 22 GPS Module
- 23 Paired with TREK-303 Specifications
- 26 Setting Jumpers and Switches
- 30 Front Side Connectors
- 30 Rear Side Connectors
- 30 Power Connector (12/24V; 9 ~ 32V)
- 30 Table 5.1: Power Connector
- 31 Smart Display Connector
- 31 Table 5.2: Smart Display Connector
- 32 RS-232 Connector (COM3)
- 32 Table 5.3: RS232 Connector(COM3)
- 32 Vehicle I/O
- 32 Table 5.4: Vehicle I/O
- 33 Generic I/O Connector
- 33 Table 5.5: Generic I/O Connector
- 36 Introduction
- 36 Execute VCIL Sample Code
- 36 System Menu
- 41 Testing VCIL
- 44 Testing CAN
- 47 Testing J
- 49 Testing ODB
- 52 Testing J
- 56 Vehicle Power Management
- 56 Power Management Mechanism
- 57 Power Management demo program
- 61 WatchDog Sample Code
- 62 Peripheral Control Demo Program
- 66 Paired with TREK-303 Specifications
- 66 Table A.1: TREK-303 Specification
- 69 Figure A.1 Hotkey utility