- No category
advertisement
Rib
Option with stop valve
Straine
Inlet nozzle
Inlet nozzle
White for Hydra XS
Black for S
Turbine
View from above
Rib
Sprinkler insert
Note: If you want a higher rotational speed, the rib must be pointing to a smaller diameter than that of the nozzle actually being used.
Perrot REGNERBAU CALW GmbH Industriestraße 19-29 / D-75382 Althengstett / Germany
Telefon : +49-7051-162-0 / Fax : +49-7051-162–133
E-mail : [email protected]
/ E-mail Konstruktion : [email protected]
7.2 Fitting the sprinkler insert
Fit O-ring onto flange and lightly grease for easier assembly.
Fit sprinkler module inside housing.
Ensure correct alignment.
Guide housing
Sprinkler insert
Guide ribs
Push flange down as far as it will go.
Fit retaining ring.
Retaining ring must be fully inserted into the slot.
Unclip snap-fit lid from the housing.
Check sprinkler is working properly as per point’s 5b-5e.
Perrot REGNERBAU CALW GmbH Industriestraße 19-29 / D-75382 Althengstett / Germany
Telefon : +49-7051-162-0 / Fax : +49-7051-162–133
E-mail : [email protected]
/ E-mail Konstruktion : [email protected]
8 Valve insert removal / installation
Ensure sprinkler is not under pressure.
Using a big screwdriver, unclip the lid
Using a screwdriver, remove white retaining ring
Retaining ring
Retaining ring
Hollow screw
Pull sprinkler insert out of the housing
8.1 Taking out the valve
Take off upper and lower retaining ring by hand.
Screw valve lifter / coarse filter wrench onto valve insert’s studs and manually tighten.
Pull out valve insert complete with valve lifter and unscrew. Valve insert is now held
on hollow screw by O-ring only.
Perrot REGNERBAU CALW GmbH Industriestraße 19-29 / D-75382 Althengstett / Germany
Telefon : +49-7051-162-0 / Fax : +49-7051-162–133
E-mail : [email protected]
/ E-mail Konstruktion : [email protected]
8.2 Taking out the coarse filter – only if seen to be dirty
Insert valve lifter / coarse filter wrench into the filter’s slots, turn and pull out.
Insert flushing equipment and fix with retaining ring.
Flush sprinkler / pipes thoroughly
Perrot REGNERBAU CALW GmbH Industriestraße 19-29 / D-75382 Althengstett / Germany
Telefon : +49-7051-162-0 / Fax : +49-7051-162–133
E-mail : [email protected]
/ E-mail Konstruktion : [email protected]
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 20 SICHERHEIT
- 21 BESCHREIBUNG
- 22 INSTALLATION
- 22 SONDERWERKZEUGE
- 23 INBETRIEBNAHME / WINTERFESTMACHUNG
- 24 SEKTOR EINSTELLEN
- 27 DÜSE TAUSCHEN
- 31 AUSBAU / EINBAU VENTILEINSATZ ( NUR BEI VENTILREGNER )
- 35 AUSBAU / EINBAU DER STEUEREINHEIT ( NUR BEI VENTILREGNER )
- 36 VENTILREGNER )
- 37 WARTUNG
- 38 BETRIEBSSTÖRUNGEN + BEHEBUNG