Stanley GD50 User Manual

SAFETY PRECAUTIONS

Tool operators and maintenance personnel must always comply with the safety precautions given in this manual and on the stickers and tags attached to the tool and hose.

These safety precautions are given for your safety. Review them carefully before operating the tool and before performing general maintenance or repairs.

Supervising personnel should develop additional precautions relating to the specific work area and local safety regulations. If so, place the added precautions in the space provided in this manual.

The GD50 Hydraulic Rod Driver will provide safe and dependable service if operated in accordance with the instructions given in this manual. Read and understand this manual and any stickers and tags attached to the tool and hoses before operation. Failure to do so could result in personal injury or equipment damage.

• To avoid personal injury or equipment damage, all tool repair, maintenance and service must only be performed by authorized and properly trained personnel.

• Always replace parts with replacement parts recommended by Stanley Hydraulic Tools.

• Check fastener tightness often and before each use daily.

• Operator must start in a work area without bystanders. The operator must be familiar with all prohibited work areas such as excessive slopes and dangerous terrain conditions.

• Establish a training program for all operators to ensure safe operation.

• Do not operate the tool unless thoroughly trained or under the supervision of an instructor.

• Always wear safety equipment such as goggles, ear and head protection, and safety shoes at all times when operating the tool.

• Do not inspect or clean the tool while the hydraulic power source is connected. Accidental engagement of the tool can cause serious injury.

• Always connect hoses to the tool hose couplers before energizing the hydraulic power source. Be sure all hose connections are tight.

• Do not operate the tool at oil temperatures above

140 °F/60 °C. Operation at higher temperatures can cause higher than normal temperatures at the tool which can result in operator discomfort.

• Do not operate a damaged, improperly adjusted, or incompletely assembled rod driver.

• Do not weld, cut with an acetylene torch, or hardface the rod driver anvil or guide housing.

GD50 User Manual ◄ 5