1.0 Introduction. Motorola AP-6511E

Installation Guide

1 Introduction

The AP-6511E is an enterprise class 802.11n Access Point, installed in minutes anywhere a CAT-5 (or better) cable is located. The AP-6511E’s mechanical design is optimized for installation over a standard CAT-5 (or better) wall jack. The AP does not protrude into the wall cavity, allowing for an efficient heat transfer and a universal installation over a standard Telco wiring plate. The AP-6511E’s modular design allows the end-user to add switched

Ethernet ports as-needed, and attach a standard keystone or Leviton QuickPort® modular connector to the wall plate.

The AP-6511E Access Point ships with a single dual-band radio supporting the 802.11a/b/g/n radio bands.

The AP-6511E receives all power and transfers data through the same CAT-5 or better Ethernet cable. There is no additional power supply required. An 802.3af PoE Ethernet switch or mid span power injector is required.

The AP-6511E can be ordered for US deployment (AP-6511E-60010-US), deployment in Europe

(AP-6511E-60010-EU) or deployment outside of the US or Europe (AP-6511E-60010-WR).

1.1 Document Conventions

The following graphical alerts are used in this document to indicate notable situations:

5

NOTE

Tips, hints, or special requirements that you should take note of.

!

CAUTION

Care is required. Disregarding a caution can result in data loss or equipment malfunction.

WARNING!

Indicates a condition or procedure that could result in personal injury or equipment damage.