- Industrial & lab equipment
- Electrical equipment & supplies
- Electrical controls
- Electrical timers
- Advantech
- TPC-1570H
- User manual
advertisement
4.3.2 How to Use the TPC-1570H Watchdog Timer
Step 1: Open the Control Panel and click Watchdog Service Configuration.
Step 2: Click the Start Service button.
TPC-1570H User Manual 38
Step 3: Click Setting to select the setting page.
Step 4: Select the Timer Span that meets your application requirement.
39 Chapter 4
Step 5: Click Enable to enable the setting.
Step 6: Check the Start watchdog service on boot to enable the Watchdog timer to start automatically after the system boots every time.
Step 7: Click OK, then the configuration procedure is finished.
Note Use Advantech WDT Driver.WDT was enable,and WDT LED was 1Hz glisten.
TPC-1570H User Manual 40
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 12 1 General Information
- 12 Introduction
- 12 Specifications
- 12 System Kernel
- 13 I/O Ports
- 13 Safety and Environment
- 14 LCD Specifications
- 15 Touchscreen Specifications
- 15 Power
- 15 I/O Port Arrangement
- 15 Figure 1.1:I/O port arrangement
- 16 Panel Mounting
- 16 Figure 1.2:Panel Mounting
- 17 Exploded Diagram
- 17 Figure 1.3:Exploded Diagram
- 17 Dimensions and cutout
- 18 Figure 1.4:Dimensions
- 20 2 System Setup
- 20 Figure 2.1:Unpack the package
- 21 Figure 2.2:Install CompactFlash memory card
- 22 Figure 2.3:Power connector
- 23 Figure 2.5:Touchscreen Calibration
- 23 Figure 2.6:Touchscreen Calibration
- 26 3 System Engine
- 27 Figure 3.1:Main Board Connector
- 27 Figure 3.2:Main Board Connector
- 30 4 Software Configuration
- 30 Utilities & Drivers
- 30 Intel Chipset Software Installation Utility
- 30 VGA Drivers (Intel(R) Graphics Driver)
- 30 Intel PRO Network Drivers/software
- 31 Audio Driver
- 31 Advantech COM Driver
- 31 Touchscreen Driver
- 31 Watchdog Timer Driver
- 32 Advantech COM Driver Installation
- 42 Watchdog Timer (WDT) Driver Installation
- 43 Installing the TPC-1570 Watchdog Timer Driver
- 48 How to Use the TPC-1570H Watchdog Timer
- 51 Dual Display Setting
- 54 5 Windows XP Embedded
- 55 Advantech Utilities
- 55 Version Information
- 55 OSLock and OSUnLock
- 58 Appendix A Serial Port Settings
- 58 COM1/ COM3 Connector Definition
- 58 COM4 Setting
- 62 Appendix B Watchdog Timer on WinCE
- 62 DeviceIOControl
- 64 How to Use the Control Code
- 66 Examples
- 70 Overview
- 71 Watchdog Timer Programming
- 72 Table C.1:Watchdog Timer Registers
- 73 Example Programs
- 80 Appendix D Accessory Kit Assembly
- 80 CompactFlash to IDE Transfer Kit
- 80 Figure D.1:Adapter Board and IDE Cable
- 81 Figure D.3:CompactFlash Slot
- 81 Figure D.5:Inserted Adapter Board
- 82 Figure D.7:Plug Power Line into CD-ROM Drive
- 82 USB Driver Installation Notice
- 84 Appendix E HDD Kit Assembly
- 84 Figure E.1:Removing the Rear Cover
- 84 Figure E.2:Removing the Top Screws
- 85 Figure E.3:Removing the HDD kit
- 85 Figure E.4:Pulling out the HDD bracket
- 86 Figure E.5:The HDD Bracket
- 86 Figure E.6:Installing the HDDr
- 87 Figure E.7:Linking the HDD with the Connector
- 87 Figure E.8:Fastening the HDD cover
- 88 Figure E.9:Chamfer
- 88 Figure E.10:Chamfer & Rubber
- 89 Figure E.11:Sliding the HDD Into Position
- 89 Figure E.12:Completed HDD Installation
- 90 Figure E.13:Mounting the Rubber Cushions
- 90 Figure E.14:Fastening the HDD Module
- 91 Figure E.15:Reinstalling the Rear Cover
- 94 Driver Installation
- 94 Figure F.1:Setup.exe
- 94 Figure F.2:Install - Wizard
- 95 Figure F.3:Install – License Agreement
- 95 Figure F.4:Install – Completed
- 96 Uninstall the Driver
- 96 Figure F.5:Uninstall
- 96 Figure F.6:Uninstall
- 97 Figure F.7:Uninstall
- 97 Touchscreen Calibration
- 98 Figure F.8:Standard Calibration
- 98 Figure F.9:Standard Calibration
- 99 Figure F.10:Standard Calibration
- 100 Figure F.11:Advanced Calibration
- 100 Figure F.12:Advanced Calibration
- 101 Figure F.13:Plot Calibration Data
- 102 Figure F.14:Draw
- 102 Figure F.15:Clear Screen
- 103 Figure F.16:Option
- 106 Appendix G Fuse Specifications
- 106 Fuse Specifications
- 106 Fuse Replacement
- 106 Figure G.1:Fuse Replacement