Record your model’s information

Whenever you call to request service for your heater, you need to know your model number and serial number.

You can find this information on the base of your heater.

Please also record the purchase date of your appliance and your dealer’s name, address, and telephone number.

Model Number

Serial Number

Purchase Date

Dealer Name

Dealer Address

Dealer Phone

_____________________________________

_____________________________________

_____________________________________

_____________________________________

_____________________________________

_____________________________________

Our Consumer

Assistance

Centre number is.

Tel.: 1-450-796-4333

Fax.: 1-450-796-4365

Keep this book and the sales slip together in a safe place for future reference.

Heat Pump Swimming Pool Heaters

I pg 03

GENERAL SAFETY INSTRUCTIONS

We care for our customers

We have provided important safety messages in this manual and on your heater. Always read and obey all safety messages.

!

WARNING

This is the safety alert symbol.

This symbol alerts you to hazards that can kill or hurt you and others.

!

VITAL

This is a very important label.

This symbol alerts you of things that MUST be strictly adhered to in order to ensure that your warranty will not be voided.

IMPORTANT

These are things that must be respected in order to protect the bathers health of the swimmers and to ensure that your warranty will not be voided.

To find detailed product information, the location of the nearest Waterco dealer or to register your heater online, please visit our website at

www.waterco.com

!

WARNING

All electrical connections must be done by a qualified electrician, according to the local electrical codes. Always cut off the unit’s main power whenever the access panel is open or removed. Always install the machine outdoors

(unless approved by the manufacturer), while respecting the minimal clearances needed for proper operation and heating.

IMPORTANT

PROPER POOL CHEMISTRY IS VITAL TO THE LIFE OF YOUR HEATER. PAY PARTICULAR ATTENTION TO THE

TOTAL ALKALINITY AND TOTAL DISSOLVED SOLIDS. IT IS HIGHLY RECOMMENDED THAT YOU HAVE YOUR

POOL CHEMISTRY CHECKED OFTEN BY AN OUTSIDE INDEPENDENT POOL STORE.

Water quality standards that must be strictly adhered to:

DESCRIPTION

PH Level

Chlorine Concentration

Total Alkalinity

Total Dissolved Solids

Calcium Hardness

NORMAL RANGE*

7.4 to 7.8

1.0 to 4.0 PPM

100 to 120 PPM below 1800 PPM Reg. Pool below 3500 PPM Salt. Pool

200 to 300 PPM

VERIFY

1 / week

1 / 2-3 days

1 / 2-3 weeks

1 / month

1 / month

1 / month

!

VITAL

MAKE SURE THE INSTALLATION WAS DONE ACCORDING TO THE INSTRUCTIONS OF THIS MANUAL.

SEE “INSTALLATION” SECTION.

MAKE SURE YOUR HEATER WAS PROPERLY GROUNDED AND BONDED. SEE “BONDING” AND “BONDING

DIAGRAM” SECTIONS.

READ YOUR WARRANTY ON PAGE 23.

Heat Pump Swimming Pool Heaters

I pg 05

DO NOT DEPRIVE HEATER OF WATER FLOW FOR MORE THAN 24 HOURS WITHOUT DRAINING IT. Make sure you leave the bypass valves open as shown in figure 1.

At the beginning of each season you must properly balance your water according to the standards prescribed on the previous page BEFORE circulating water inside the heat pump.

At the end of each season, if the heater is no longer used, and proper pool water chemistry is not maintained, it should be disconnected from the water line and drained to prevent any possible corrosion.

COMPONENTS DESCRIPTION

1. Heat Control

2. Evaporator

3. Cabinet

4. Fan and Motor

5. Heat Exchanger

6. Compressor

5

Inside the heater

2

3

4

1

6

Inside the heater