- No category
advertisement
6 Safety, Compliance and Approvals
6.1 Safe Operating Procedures
•
Ensure that the power supply arrangements are adequate to meet the stated requirements of each LDRLink product.
•
Operate within the environmental limits specified for the product.
•
Do not subject the indoor equipment to splashing or dripping liquids.
•
Only authorized, trained personnel should open the product. There are no functions that required the User to gain access to the interior of the product.
6.2 EMC / Safety and Radio Approvals
The equipment has been designed to meet and has been tested against the following harmonized EMC and safety standards:
•
EN 301 489-1 & EN 301 489-5
•
EN 61000-3-2:2000
•
EN 61000-3-3:1995
•
EN 55022:1998, Class B
•
EN 61000-4-2:1995
•
EN 61000-4-3:1996
•
EN 61000-4-4:1995
•
EN 61000-4-5:1995
•
EN 61000-4-6:1996
•
EN 61000-4-11:1994
•
EN 60950:2000
6.3 CE marking
The CE mark is affixed to the LDRLink product, and the CE Declaration of
Conformity, as well as the technical file are available on request.
7
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 2 Table of Contents
- 3 Change History
- 4 About this Manual
- 5 Introduction
- 6 Warranty and Support
- 6 Warranty Cover
- 7 Safety, Compliance and Approvals
- 7 Safe Operating Procedures
- 7 EMC / Safety and Radio Approvals
- 7 CE marking
- 8 Getting Started and Basic Operation
- 8 Which Model do I have?
- 9 Controls
- 10 Getting Started with the LDR Link Transmitter
- 12 Getting Started with the LDR Link Receive System
- 15 Powering on the System
- 18 Advanced Operation
- 18 Technical Overview
- 19 SOLO4 System PC Controller Application Software
- 21 LDR Link Transmitter Control Application
- 25 LDR Link Receiver Control Application
- 30 Fault Finding
- 30 Fault Symptoms
- 31 LED Indicators
- 31 LDR Link TX
- 31 LDR Link RX
- 32 Technical Specifications
- 32 Bandwidths and Bitrates
- 32 SOLO4 Telemetry Transmitter
- 33 LDR Link Telemetry Receiver
- 34 Connector Pin Outs
- 34 LDR TX and RX - Power Amphenol
- 34 LDR TX and RX - Control Amphenol
- 34 LDR TX and RX – Video Amphenol
- 35 Control Protocols
- 35 RS232 Control – General Principles
- 35 Packet Structure Sending (from PC)
- 36 Packet Structure Reply (from controlled device)
- 37 Telemetry System Command List
- 39 Typical Ranges of the LDR Link Product