- Computers & electronics
- Networking
- Gateways/controllers
- American Time
- AllSync Wired Master Clock ASMA – Signal Programmer
- Owner's manual
GPS Menu. American Time AllSync Wired Master Clock ASMA – Signal Programmer
Add to My manuals65 Pages
advertisement
![GPS Menu. American Time AllSync Wired Master Clock ASMA – Signal Programmer | Manualzz GPS Menu. American Time AllSync Wired Master Clock ASMA – Signal Programmer | Manualzz](http://s1.manualzz.com/store/data/007153686_1-fe4dc86af9f35732d0f906c490627a23-360x466.png)
Programming
AllSync Master Installation &
Operation Manual
GPS Menu
GPS refers to the time reference signal from the Global Positioning System satellites. An optional GPS receiver is required to access this time reference. Figure 9 shows the GPS menu structure. To reach the
GPS Time menu press PROG, 5.
At this screen:
To check GPS signal status:
1. Press 1. The screen shows the most recent time that the signal was
received.
2. Press OK to view the number of satellites within range.
3. Press OK to return to the GPS Time menu.
To enable or disable the GPS signal as a time reference:
1. Press 2
2. Enter User Lock
The Choose screen appears:
Press 1 to enable or 2 to disable the GPS receiver.
To exit the GPS menu press BACK.
36
Figure 9 - GPS Menu
© American Time
advertisement
Related manuals
advertisement
Table of contents
- 6 Safety Precautions
- 7 Introduction
- 8 Installation
- 8 Mounting Master Clock
- 10 Mounting Optional GPS Antenna
- 10 Electrical Connections
- 12 Signal Circuit Connections
- 12 Ethernet
- 12 GPS Kit
- 13 User Interface
- 13 Keypad & LCD
- 14 Reset Switch
- 15 Configuration & Operation
- 16 Programming
- 16 Program Menu
- 22 Event Menu
- 32 Signal Circuit Menu
- 36 GPS Menu
- 37 Checking Status Menu
- 38 Configuration Menu
- 44 Changing Communications Settings
- 46 Changing Clock Type
- 47 Adjust Time Menu
- 48 Troubleshooting Guide
- 49 Appendix A - Clock Circuit Wiring Diagrams
- 56 Appendix B - Specifications
- 57 Appendix C - Supported Time Zones
- 58 Appendix D - IP Addresses of Selected Time Servers
- 59 Appendix E - Events Programming Table
- 60 Appendix F - Mounting Template
- 61 Appendix G - Typical Tone Generator Wiring
- 62 Glossary of Terms