- No category
advertisement
The Scanner Manual
The Scanner is designed to be mounted to a tree or pole. For ease of installation, we recommend using the mounting bracket included with the Scanner's installation kit. This kit contains all the equipment needed to install the Scanner in the field.
Installing the Mounting Bracket
The mounting bracket included with the Scanner is designed to help make the installation of the unit as easy as possible. This bracket can be attached to the back of The Scanner using the steps described below.
Insert a long screw through one of the screw holes in the front of The
Scanner. Using the screwdriver included with the kit, attached one of the L clamps to the back of the unit, facing inward.
Repeat the process to attach the second L clamp to the back of the unit.
3-2 3-3
advertisement
Related manuals
advertisement
Table of contents
- 42 Chapter 1 - Using The Scanner
- 42 What is The Scanner?
- 42 How it Works
- 42 Setting Up The Scanner
- 42 Main Screen
- 42 Selecting Options
- 42 Reset Screen
- 42 Start Time-stamped Study Screen
- 42 GPS Screen
- 42 Clear Memory Screen
- 42 Uploading Information to the Scanner
- 42 Downloading the Scanner with JRead
- 43 Chapter 2 - Using the JPDA Software
- 43 Introduction to JPDA
- 43 Installing JPDA
- 43 Installing JRead
- 43 Getting Started with JPDA
- 43 Main Menu
- 43 Preferences Screen
- 43 Setup Screen
- 43 Status Screen
- 43 Ext. IR Screen
- 43 Retrieving Data from the Scanner
- 43 Transferring Data from JPDA with JRead
- 44 Chapter 3 - Installing The Scanner
- 44 Installing the Mounting Bracket
- 44 Installing the Scanner in the Field
- 44 What Makes for a Good Location?
- 45 Chapter 4 - Battery Care
- 46 Chapter 5 - Troubleshooting