7. Possible Malfunctions. Bartscher 150151

CAUTION!

Never immerse the motor block in water or other liquids, do not wash it in the running water or dishwasher.

o

Wipe the motor block and the supply cable with soft, moistened cloth. Protect the device from the water penetration. Dry the device thoroughly with soft, dry cloth.

o

Always use the soft cloth only, never use any abrasive cleaning agents which may damage the device surfaces. o

In case of longer inactivity period clean the device according to the description above and store in dry and clean place, protected from frost, sunlight, and out of reach of children. o

Do not place any heavy objects on the device.

7. Possible Malfunctions

In case of anomalies use the table below before calling the service company or informing the vendor.

Problem

The device is connected to the power supply but the

ON/OFF button lamp is not working

Cause

•

Plug improperly inserted into socket.

•

The ON/OFF button is not pressed.

•

The overload / overheating protection was triggered.

The ON/OFF button lamp illuminates, the speed level is selected but the device is not working.

•

The device worked for too long and turned off automatically.

Solution

•

Remove the plug and insert it properly into the socket.

•

Press the ON/OFF button

•

Press RESET button located in the device bottom. (See fig. in page 27)

•

Remove the plug and leave the device for cooling down before reactivation. If the protection is triggered again contact the vendor.

When the anomalies cannot be removed:

disconnect the device from the socket (pull the plug!)

do not open the housing

contact the vendor.

- 31 -