advertisement
DXS-3600-32S 10GbE Layer 2/3 Switch CLI Reference Guide
LINE Commands
29-1 line
This command is used to enter the specified LINE mode. The no form of this command is used to restore the default configuration.
line {console | telnet | ssh} no line {console | telnet | ssh}
Parameters console telnet ssh
Specifies the console port.
Specifies the Telnet terminal line.
Specifies the SSH terminal line.
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 15
Usage Guideline
Access to the specified LINE mode.
Example
This example shows how to enter the LINE mode from LINE CONSOLE.
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#line console
DXS-3600-32S(config-line)#
29-2 exec-timeout
This command is used to configure the connection timeout to this equipment in the LINE, use the exec-timeout command. Once the connection timeout in the LINE is cancelled by the no exec-timeout command, the connection will never be timeout.
exec-timeout minutes [seconds]
no exec-timeout
Parameters
minutes seconds
Specifies the minutes of specified timeout. This value must be between 0 and 1439.
(Optional) Specifies the seconds of specified timeout.
Default
The default timeout is 10min.
Command Mode
Line Configuration Mode.
Command Default Level
Level: 15
Usage Guideline
If there is no input/output information for this connection within specified time, this connection will be interrupted, and this LINE will be restored to the free status.
Example
This example shows how to specify the connection timeout is 5’30”.
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#line console
DXS-3600-32S(config-line)#exec-timeout 5 30
DXS-3600-32S(config-line)#
272
DXS-3600-32S 10GbE Layer 2/3 Switch CLI Reference Guide
29-3 speed
This command is used to set the speed at which the terminal transmits packets, execute the speed speed command in the line configuration mode. To restore the speed to its default value, run the no speed command.
speed speed
no speed
Parameters
speed
Specifies the transmission rate (bps) on the terminal. For serial ports, the optional rates are 9600, 19200, 38400, and 115200 bps. The default rate is 115200 bps.
Default
Command Mode
The default rate is 115200.
Line Configuration Mode.
Command Default Level
Level: 15
Usage Guideline
This command sets the speed at which the terminal transmits packets. It is only applicable for serial ports.
Example
This example shows how to configure the rate of the serial port to 115200 bps.
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#line console
DXS-3600-32S(config-line)#speed 115200
DXS-3600-32S(config-line)#
29-4 show line
This command is used to show the configuration of a line.
show line {console | telnet | ssh}
Parameters console telnet ssh
Displays the configuration of a console line.
Displays the configuration of a telnet line.
Displays the configuration of a telnet line.
Default
Command Mode
None.
Privileged EXEC Mode.
Command Default Level
Level: 15
Usage Guideline
This command shows the configuration information of a line.
Example
This example shows the configuration of console port.
DXS-3600-32S#show line console
Type: console
Speed: 115200
Timeout: 0 hour 10 min 0 sec
DXS-3600-32S#
273
DXS-3600-32S 10GbE Layer 2/3 Switch CLI Reference Guide
274
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement