DXS-3600-32S CLI Reference Guide

DXS-3600-32S 10GbE Layer 2/3 Switch CLI Reference Guide

Network Connectivity Test Commands

36-1 ping

This command is used to test the connectivity of a network.

ping {[ip] ip-address | host-name} [ntimes times] [timeout seconds] [source source]

Parameters

ip-address host-name times seconds source

Specifies the destination IPv4 address.

Specifies the destination’s host name.

Specifies the number of packets to be sent.

Specifies the time out value.

Specifies the source IPv4 address.

Default

By default the times is infinity, the timeout is 1 second.

Command Mode

Privileged Mode.

Command Default Level

Level: 1

Usage Guideline

This command tests the connectivity of a network.

Example

This example shows how to tests the connectivity of a network.

DXS-3600-32S#ping ip 192.168.69.66

Reply from 192.168.69.66, time<10ms

Reply from 192.168.69.66, time<10ms

Reply from 192.168.69.66, time<10ms

Reply from 192.168.69.66, time<10ms

Ping Statistics for 192.168.69.66

Packets: Sent =4, Received =4, Lost =0

DXS-3600-32S#

36-2 traceroute

This command is used to trace the routed path between the switch and a destination end station.

traceroute {[ip] ip-address | host-name} [probe number] [timeout seconds] [ttl maximum]

Parameters

ip-address host-name number seconds maximum

Specifies the IPv4 address of the destination end station.

Specifies the host name of the destination end station.

Specifies the number of probe packets for each TTL.

Specifies the timeout period while waiting for a response from the remote device.

Specifies the maximum number of routers that a trace route packet can cross, while seeking the network path between two devices.

Default

Command Mode

The default probe number is 1, timeout is 5 seconds and maximum TTL is 30.

Privileged Mode.

Command Default Level

Level: 1

310

Usage Guideline

DXS-3600-32S 10GbE Layer 2/3 Switch CLI Reference Guide

This command is used to trace the routed path between the switch and a destination end station.

Example

This example shows how to trace the routed path between the switch and a destination end station.

DXS-3600-32S#traceroute 30.1.1.1

<10 ms 20.1.1.1

<10 ms 30.1.1.1

Trace complete.

DXS-3600-32S

311