WDB 030-AU-en

Spinning

Final spin speed

Programme

Cottons 

Cottons

Minimum iron

Delicates

Woollens 

Shirts

Express 20

Dark garments/Denim

Outerwear

Proofing

Drain/Spin

Separate rinse/Starch

Max. possible rpm

1400

1400

1200

900

1200*

900

1200

1200

900

1200

1400

1200

Final spin speed in the programme

When a programme is selected, the sensor for the optimum spin speed for that programme will be brightly lit up in the control panel. For programmes marked with a * in the chart, the optimum spin speed is not the maximum spin speed.

You can reduce the final spin speed or, depending on the programme, increase it.

However, you cannot select a final spin speed higher than that shown in the chart.

Rinse and interim spin

There is a spin after the main wash and between the rinses. A reduction in the final spin speed will also reduce the interim spin speed. If a spin speed of less than 700 rpm is selected for the

Cottons programme, an additional rinse is introduced.

28

Spinning

Omitting the final spin (Rinse hold)

 Touch the  sensor (Rinse hold).

The laundry is not spun after the final rinse and remains in the rinse water.

This helps prevent creasing if the laundry is not going to be removed from the drum immediately after the end of the programme.

After the end of a programme

The sensor for the optimum spin speed lights up in the control panel.

You can change the spin speed. The

Start/Stop sensor will light up, flashing.

 Start the final spin: touch the flashing Start/Stop sensor once.

The final spin is carried out.

 End the programme: touch the flashing Start/Stop sensor twice.

The water will be pumped away.

Omitting rinse and interim spin and the final spin

 Touch the  sensor.

After the last rinse, the water will be pumped away and the anti-crease phase will switch on.

In some programmes an additional rinse is introduced with this setting.

29