Date of Issue:
Version:
Installation Note
VASCO DIGIPASS CCID Filter Driver
15-11-2013
2.1
Copyright © 2013 VASCO Data Security
Installation Note, VASCO DIGIPASS CCID Filter Driver
Disclaimer of Warranties and Limitation of Liabilities
All information contained in this document is provided 'as is'; VASCO Data Security assumes no responsibility for its accuracy and/or completeness.
In no event will VASCO Data Security be liable for damages arising directly or indirectly from any use of the information contained in this document.
Copyright
VASCO Data Security 2013. All rights reserved.
No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of VASCO Data Security.
Trademarks
DIGIPASS and VACMAN are trademarks of VASCO Data Security.
All other trademarks referenced are trademarks of their respective owners.
Copyright © 2013 VASCO Data Security
15-11-2013 INS-CCIDFilter-v2.1.doc 2.1
Installation Note, VASCO DIGIPASS CCID Filter Driver
Contents
Related documents ........................................................................................................................ 4
1 Introduction .......................................................................................................................... 5
1.1
System Requirements ............................................................................................... 5
1.2
Known Limitations ..................................................................................................... 5
2 Driver Installation ................................................................................................................. 6
2.1
Preparing for installation ............................................................................................ 6
2.2
Installing the VASCO DIGIPASS CCID Filter Driver ................................................. 6
3 Appendix A: Installing the Microsoft CCID driver on Windows XP .................................... 10
Table of Figures
Figure 1 – Installation welcome page ........................................................................................... 6
Figure 2 – Installation folder selection .......................................................................................... 7
Figure 3 – Ready to install ............................................................................................................ 7
Figure 4 – UAC Confirmation Prompt for administrator accounts ................................................ 8
Figure 5 – UAC Confirmation Prompt for restricted user accounts .............................................. 8
Figure 6 – Device driver signature confirmation ........................................................................... 9
Figure 7 – Setup complete ............................................................................................................ 9
Figure 8 – New Hardware Wizard ............................................................................................... 10
Figure 9 – Installation source selection ...................................................................................... 10
Figure 10 – Successful CCID driver installation ......................................................................... 11
Copyright © 2013 VASCO Data Security
15-11-2013 INS-CCIDFilter-v2.1.doc 2.1 Page 3 of 11
Installation Note, VASCO DIGIPASS CCID Filter Driver
Related documents
The following documents are referred to within this document and are considered to be included portions of this document. In those cases where this document differs from a document referenced here, this document takes precedence.
Ref Title
1 Interoperability Secification for ICCs and
Publisher
PC/SC
Workgroup
Date of issue
04-2010
Version
2.02.08
Personal Computer Systems – Part 10
IFDs with Secure PIN Entry Capabilities
2 Specification for Integrated Circuit(s) Cards
Interface Devices
USB.org 22-04-2005 1.1
Copyright © 2013 VASCO Data Security
15-11-2013 INS-CCIDFilter-v2.1.doc 2.1 Page 4 of 11
Installation Note, VASCO DIGIPASS CCID Filter Driver
1 Introduction
In order to standardize interaction with secure card readers (card readers facilitating secure PIN entry), the PC/SC 2.0 standard [1] defines a set of features and control codes that can be used to interact with the reader directly through I/O control commands.
The Microsoft USB CCID class driver used by VASCO secure card readers however discard these I/O control commands rather than forwarding them to the CCID equivalents (as defined in
[2]), effectively hiding any provided secure reader functionality from PC/SC 2.0 enabled software.
The VASCO DIGIPASS CCID filter driver circumvents this shortcoming by filtering I/O control commands before they are processed by the driver itself. This approach allows the filter driver to “re-map” the control commands to APDU calls that can be interpreted by the VASCO
DIGIPASS card reader.
The following commands and features as defined by [1] are forwarded by the VASCO
DIGIPASS CCID filter driver:
•
GET_FEATURE_REQUEST
•
FEATURE_IFD_PIN_PROPERTIES
•
FEATURE_VERIFY_PIN_DIRECT
•
FEATURE_MODIFY_PIN_DIRECT
- see [1] paragraph 2.2
- see [1] paragraph 2.6.8
- see [1] paragraph 2.6.4
- see [1] paragraph 2.6.4
PLEASE NOTE:
Screen shots in this manual may show specific readers such as the VASCO DIGIPASS 865; installation steps are however applicable to all supported readers.
1.1 System Requirements
The following hard- and software is required for using the VASCO DIGIPASS CCID filter driver:
•
Microsoft Windows XP (32 bit only), Microsoft Windows Vista, Windows 7, Windows 8 or
Windows 8.1 (32 or 64 bit).
•
Microsoft USB CCID driver;
•
VASCO DIGIPASS 855, 865, 870 or 920 card reader.
1.2 Known Limitations
•
Installation of the VASCO DIGIPASS CCID filter driver requires the Microsoft USB CCID driver to be present on the system.
Copyright © 2013 VASCO Data Security
15-11-2013 INS-CCIDFilter-v2.1.doc 2.1 Page 5 of 11
Installation Note, VASCO DIGIPASS CCID Filter Driver
2 Driver Installation
2.1 Preparing for installation
The VASCO DIGIPASS CCID Filter Driver requires the Microsoft CCID driver to be installed on the system. Connect your VASCO DIGIPASS reader to initiate the installation process; once the reader is set up with the Microsoft USB CCID driver, you can install the filter driver as described in the next paragraph.
Note for Windows XP users: Installation of the Microsoft CCID driver on Windows XP requires access to Windows Update. Before installing, make sure that you have a working internet connection. A detailed overview of the CCID driver installation procedure can be found in
Appendix A.
2.2 Installing the VASCO DIGIPASS CCID Filter Driver
Extract the downloaded files to a folder and run setup.exe. The installer will verify that the
Microsoft CCID driver is present on your system and launch the installer best fitted for your
Windows version.
Note: Windows may display additional warning messages if setup.exe is run from a network location.
Figure 1 – Installation welcome page
Click 'Next' in the welcome page to start the installation. Setup will now ask you where to install the filter driver files:
Copyright © 2013 VASCO Data Security
15-11-2013 INS-CCIDFilter-v2.1.doc 2.1 Page 6 of 11
Installation Note, VASCO DIGIPASS CCID Filter Driver
Figure 2 – Installation folder selection
Click 'Browse' to select a specific location or 'Next' to accept the default suggestion and continue. Setup is now ready to install the filter driver:
Figure 3 – Ready to install
Copyright © 2013 VASCO Data Security
15-11-2013 INS-CCIDFilter-v2.1.doc 2.1 Page 7 of 11
Installation Note, VASCO DIGIPASS CCID Filter Driver
Click 'Install' to start the installation. Depending on your Windows version and user account type, you may be prompted to confirm installation and/or to provide administrator credentials:
Figure 4 – UAC Confirmation Prompt for administrator accounts
Figure 5 – UAC Confirmation Prompt for restricted user accounts
Enter the requested administrator credentials if necessary, and click 'Yes' to continue.
Copyright © 2013 VASCO Data Security
15-11-2013 INS-CCIDFilter-v2.1.doc 2.1 Page 8 of 11
Installation Note, VASCO DIGIPASS CCID Filter Driver
Note: On Windows 7 and 8 an additional window may be displayed to confirm the driver installation:
Figure 6 – Device driver signature confirmation
Setup will now install the filter driver. After completion, click 'Finish' to close the installer.
Figure 7 – Setup complete
If so prompted, reboot the system to finalize installation. The VASCO DIGIPASS reader is now ready for use with PC/SC 2.0 enabled applications.
Copyright © 2013 VASCO Data Security
15-11-2013 INS-CCIDFilter-v2.1.doc 2.1 Page 9 of 11
Installation Note, VASCO DIGIPASS CCID Filter Driver
3 Appendix A: Installing the Microsoft CCID driver on
Windows XP
Connect the VASCO DIGIPASS reader and wait for the “Found New Hardware Wizard” dialog:
Figure 8 – New Hardware Wizard
Make sure you have a working internet connection and select “Yes, this time only” for searching
Windows Update:
Figure 9 – Installation source selection
Select “Install the software automatically (Recommended)”.
Copyright © 2013 VASCO Data Security
15-11-2013 INS-CCIDFilter-v2.1.doc 2.1 Page 10 of 11
Installation Note, VASCO DIGIPASS CCID Filter Driver
Figure 10 – Successful CCID driver installation
The Microsoft CCID driver is now installed. The reader will be listed in the device manager as
“USB Smart Card reader”. You can open the Computer Management console by right-clicking
“My Computer” in the Start menu and selecting the “Manage” menu option.
Copyright © 2013 VASCO Data Security
15-11-2013 INS-CCIDFilter-v2.1.doc 2.1 Page 11 of 11
