- Computers & electronics
- Telecom & navigation
- Power banks
- INSTEON
- Mini Remote Control Switch, 1-Scene
- Quick start Guide
INSTEON Mini Remote Control Switch, 1-Scene Quick Start Guide
Add to my manuals
2 Pages
INSTEON Mini Remote Control Switch, 1-Scene
This versatile device allows you to control your INSTEON-compatible smart home devices with ease. It features a compact and portable design, making it ideal for use in various locations around your home.
Key Features:
- Controls INSTEON devices through RF or dual-band communication.
- Single-scene operation allows you to control one specific device or scene.
- Intuitive switch paddle design:
- Tap the top for on or brighten.
- Tap the bottom for off or dim.
- Press and hold to brighten or dim gradually.
- LED indicator provides visual feedback for commands sent.
advertisement
Quick Start Guide
INSTEON
®
Mini Remote – Wireless Switch
Model: 2342-242/2444A3WH, 2342-442, 2342-542
Status LED
Getting Started
Fully charge Mini Remote prior to programming (or anytime the unit is not responding) using a Type A to Micro-B USB cable (sold separately). The red
Charging LED will turn off once the battery is fully charged (approximately one hour). Slide the power switch to the ON position.
Note: Mini Remote requires an INSTEON dual-band or RF device to communicate with other devices on your INSTEON network.
Mini Remote uses a subtle beeper sound to assist setup. It is recommended that
you program the unit in a quiet area.
Power
Switch
(Left=Off,
Right=On)
Set button
Micro-USB
Charging
Jack
Make Remote a Controller
Use Remote to control other INSTEON devices
1) Tap the top of the paddle switch
2) Press and hold Mini Remote set button until it beeps
Mini Remote LED will start blinking green
3) Turn responder on (or any other state such as on 50% or even off)
4) Press and hold responder set button until it double-beeps
Mini Remote will double-beep and its LED will stop blinking
5) Confirm that scene addition was successful by tapping the top and bottom paddle on the Mini Remote
Responder load will respond appropriately
Remote
(Controller)
Switch Paddle
(Top: On/Brighten,
Bottom: Off/Dim)
Charging LED
(inside case)
Responder
Using Mini Remote
Mini Remote switch sends commands to devices linked specifically to the paddle switch. Dimmable responders may behave differently if you tap, double-tap or press and hold the switch paddle to activate/deactivate a scene. Non-dimming responders will only turn full-on or full-off, no matter what method you use.
Tap Double-tap
Ramp to preset on-level or off Full-on or full-off instantly
Press and hold
Brighten or dim until released
The Mini Remote Status LED will flash green once for each on/brighten command sent and red once for each off/dim command sent
Warning: Mini Remote is permanently sealed. Do not attempt to open case. Doing so will damage the remote and void the warranty.
Owner’s Manual and Tech Support
Visit: http://www.insteon.com/support for complete manual, online tech support and latest product documents.
Call: INSTEON Support Line at 866-243-8022
FCC and IC Warnings
This device complies with FCC Rules and Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Le present appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorise aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible d'en compromettre le fonctionnement.
2342-242/2444A3WH, 2342-442, 2342-542 Rev. 2/20/2013 8:48 AM / See Owner’s Manual for Warranty Information.
Protected under U.S. and foreign patents (see www.insteon.com/patents )
© Copyright 2013 INSTEON, 16542 Millikan Ave., Irvine, CA 92606, 866-243-8022
Mini Remote Accessories
Wall Mount Bracket
(2444B4)
•
Wall mount your Mini Remote anywhere
•
Pair the Wall Mount Bracket with any decoratorstyle wall plate (sold separately) for the perfect wireless wall switch solution
•
Gang two or more together for more control
•
Can be installed adjacent to existing wired-in switches
•
Easily remove Mini Remote for portability or recharging
Tabletop Stand
(in 2444BWH kit)
•
Perfect for a nightstand, kitchen counter or coffee table
Visor Clip
(in 2444BWH kit)
•
Control your home from your vehicle.
•
Turn lights on when you arrive and off when you leave
USB Charging Cable (Type A to Micro-B)
(2444B5)
•
Works with Mini Remote and any other device that uses USB Type A to Micro-B
USB Power Adapter
(2444B6)
•
For use with USB Charging Cable and any other device that charges via USB cable
2342-242/2444A3WH, 2342-442, 2342-542 Rev. 2/20/2013 8:48 AM / See Owner’s Manual for Warranty Information.
Protected under U.S. and foreign patents (see www.insteon.com/patents )
© Copyright 2013 INSTEON, 16542 Millikan Ave., Irvine, CA 92606, 866-243-8022
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement