Installation Instructions
Please Read the Manual Carefully Before Installation
SCREW
TRIM-KIT PLASTIC
COVER
Please Note
Electrical connection
The oven is fitted with a plug and must be only connected to a properly installed earthed socket. In accordance with the appropriate regulations, the socket must only be installed and the connecting cable must only be replaced by a qualified electrician.
If the plug is no longer accessible following installation and all-pole isolating switch must be present on the installation side with a contact gap of at least 3mm.
1
A. Built-in furniture
The built-in cabinet shall not have a rear wall behind the appliance.
Minimum installation height is 85cm.
Do not cover ventilation slots and air intake points.
600
560 +8 min
550
380
+2
(45)
(45)
2
B. Install the Oven
UPPER AIR TUNNEL
TRIM KIT
TRIM-KIT
1. Do not trap or kink the power cord.
Make sure that the oven is installed in the center of the cabinet.
SCREW INSTALLATION HOLE TRIM-KIT PLASTIC COVER INSTALLATION HOLE
2. Open the door; fix the oven to the cabinet with SCREW at the
INSTALLATION HOLE of TRIM KIT. Then fix the TRIM-KIT PLASTIC COVER to the INSTALLATION HOLE.
PN:261800310246
3