Quick Reference Guide
Digital Proprietary Telephone
Model No.
KX-DT321
Thank you for purchasing a Digital Proprietary Telephone (DPT).
Please read this manual carefully before using this product and save this manual for future use.
For more details, please refer to the manuals of the PBX.
Accessories (included)
Handset: 1 Handset Cord: 1 Stand: 1
Screws for wall: 2 Telephone Line
Cord: 1
Location of Controls
Location of Controls
A
B
C
D
E
F
G
H
I J K L M
P
O
N
2
A LCD (Liquid Crystal
Display)
B AUTO DIAL/STORE: Used for System/Personal Speed
Dialling or storing programme changes.
C AUTO ANS (Auto Answer)/
MUTE: Used to receive an incoming call in hands-free mode or mute the microphone/handset during a conversation.
D INTERCOM: Used to make or receive intercom calls.
E MESSAGE: Used to leave a message waiting indication or call back the party who left the message waiting indication.
F REDIAL: Used to redial the last dialled number.
G TRANSFER: Used to transfer a call to another party.
H Headset Jack
I FLASH/RECALL: Used to disconnect the current call and make another call without hanging up.
Location of Controls
J HOLD: Used to place a call on hold.
K SP-PHONE
(Speakerphone): Used for performing hands-free operations.
L Navigator Key: Used to adjust the volume and the display contrast or select desired items.
M Microphone: Used for hands-free conversations.
N Flexible Buttons: Used to seize an outside line or perform a feature that has been assigned to the key.
O PROGRAM: Used to enter and exit the personal programming mode.
P Message/Ringer Lamp:
When you receive a call, the lamp flashes red. When someone has left you a message, the lamp stays on red.
3
Settings
Settings
Speaker volume
While in a hands-free conversation
Handset/Headset volume
*1
While using the handset or headset
Ringer volume
While on-hook or receiving a call
LCD Contrast
While on-hook
PROGRAM
AUTO DIAL
STORE
Press Up to increase or Down to decrease the volume.
AUTO DIAL
STORE
PROGRAM
Ring Tone
PROGRAM
(CO)
*2
AUTO DIAL
STORE
PROGRAM
INTERCOM
Press 2 times.
*1
*2
If you hear your own voice through the handset or headset, decrease the volume.
The ring tone pattern of patterns 09 to 30 is the same as pattern 01.
4
Features List
Features List
Icon Meanings
(CO)
= Flexible button
= Feature number
= Off-hook
= Talk
= On-hook
C. Tone
= Confirmation Tone
Making Calls
To an extension extension no.
Calling
To an outside party outside phone no.
(CO)
Redial
REDIAL
Quick Dialling quick dial no.
One-touch Dialling
To store
PROGRAM
(CO)
desired no.*
(max. 32 digits)
AUTO DIAL
STORE
* Enter outside line access number
before outside phone number.
PROGRAM
To dial
(One-touch
Dialling)
assigned as a
One-touch Dialling button
5
6
Features List
Personal Speed Dialling
To store personal speed dialling no. (2 digits) desired phone no.*
(max. 32 digits)
C. Tone
* Enter outside line access number before outside phone number.
To dial
AUTO DIAL
STORE
personal speed dial no. (2 digits)
System Speed Dialling
To dial
AUTO DIAL
STORE
system speed dial no. (3 digits)
Doorphone Call doorphone no. (2 digits)
C. Tone
During a Conversation
To hold
HOLD
C. Tone
Call Hold
To retrieve a call at the holding extension
(CO)
/
INTERCOM
To retrieve an outside call from another extension
(CO)
Call Transfer
TRANSFER
C. Tone
extension no.
(CO)
outside
To an extension
phone no.
To an outside party
Features List
Useful Features
Multiple Party Conversation
To add other parties during a conversation (i.e., conference)
(Conference)
assigned as a
Conference button
C. Tone
(Conference)
assigned as a
Conference button
C. Tone
desired phone no.
Talk with
Talk to the new party.
multiple parties.
To leave a conference
(Conference)
assigned as a
Conference button
C. Tone
Setting the Telephone According to Your Needs
Do Not Disturb
Both Calls
Outside Calls
Intercom Calls
Set
Cancel C. Tone
Timed Reminder
To set
12 H hour/minute
(4 digits)
24 H hour/minute
(4 digits)
AM
PM
Once
Daily
C. Tone
To cancel
C. Tone
To stop or answer the ring back
INTERCOM
/
7
Features List
Before Leaving Your Desk
Call Forwarding
Both Calls
Outside Calls
Intercom Calls
All calls
Busy
No answer
Busy/
No answer
Cancel extension no.
OR
outside line access no.
outside phone no.
C. Tone
Making Use of the Voice Mail Service
Listening to a message
From your own extension
VPS extension no.
Mailbox Password*
* If you have no password, you can skip the last step.
Note: VPS = Voice Processing System
From someone else’s extension
VPS extension no.
KX-TVM series
Listen to Message
Deliver Message
Mailbox Management
Automated Attendant
Message Notification
Other Features
End Call
mailbox no.
KX-TVP series
Listen to Message
Deliver Message
Mailbox Password*
* If you have no password, you can skip the last step.
Check Mailbox Distribution
Automated Attendant
Mailbox Management
Other Features
End Call
8
Features List
Leaving a message
VPS extension no.
From your own extension
Mailbox Password*
From someone else’s extension mailbox no.
Mailbox Password*
* If you have no password, you can skip the last step.
Enter the desired mailbox number
Leave a message
To send the message immediately
(KX-TVM series)
(KX-TVP series)
To set the delivery time
Follow the guidance
During playback
Repeat Voice Guidance
Exit
• Consult your dealer for more details regarding feature numbers.
• It is possible to assign flexible buttons as feature buttons.
• Control panel/button names and descriptions can be found in "Location of Controls" on page 2.
9
Connection
Connection Note: In the illustration below, the telephone line cords are routed for wall
mounting. When using the stand, refer to "Attaching the Stand" and
"Cabling" on page 11 for telephone line cabling.
<Back view> The telephone line cord
(included)
Connect to a PBX.
Connect to a digital proprietary telephone
— Digital XDP connection
Clamp
Headset
Recommended: KX-TCA89
• Consult your dealer for more details about Digital XDP.
CAUTION:
When connecting a headset
• Ensure that the headset cord is wound around the hook to prevent damage to the connector.
When connecting cords
• Ensure the cords are inserted in the grooves, and are clamped to prevent damage to the connectors.
• When mounting the unit on the wall, cords may be routed upwards or downwards by using the appropriate cord clamp located on the back of the unit.
10
Stand Usage
Stand Usage
Attaching the Stand
Place the catches (
A
) of the stand into hooks located in the unit.
Gently push the stand in the direction indicated until it locks into place. The stand will be mounted in the high position.
A
Removing the Stand
Hold the stand with both hands.
Gently rotate the stand in the direction indicated until it is released.
Cabling
When using the stand, ensure that the cords are clamped as shown.
Clamp
11
Stand Usage
Adjusting from High to Low Position
Hold the stand with both hands as shown and rotate the stand in the direction indicated until it locks into the low position (
B
).
1
Adjusting from Low to High Position
B
Hold the stand with both hands as shown and rotate the stand in the direction indicated until it locks into the high position (
A
).
1
A
12
Wall Mounting
Wall Mounting
1. Remove the stand if it is attached. For information on removing
the stand, refer to page 11.
2. Drive the 2 screws (included) into the wall either 83 mm or 100 mm apart, and mount the unit on the wall.
• You can find a wall mounting
template on page 19.
• Make sure that the wall that the unit will be attached to is strong enough to support the unit
(approx. 730 g).
• Make sure that the telephone line cords are not trapped or pinched against the wall.
• Make sure the cords are securely fastened to the wall.
• When this unit is no longer in use, make sure to detach it from the wall.
83 mm
100 mm
Washer
Drive the screw to this point.
Locking the Handset Hook
Pull down the handset hook until it locks to prevent the handset from falling off the handset cradle when the unit is mounted to a wall or set at a high angle. To temporarily place the handset down during a conversation, hook it over the top edge of the unit as shown.
13
Important Information
Important Information
When using a KX-DT321 DPT, keep the following conditions in mind.
• If you are having problems making calls, unplug the extension line and connect a known working telephone. If the known working telephone operates properly, have the defective telephone repaired by an authorised Panasonic factory service centre. If the known working telephone does not operate properly, check the PBX and the internal extension wiring.
• Wipe the unit with a soft cloth. Do not clean the unit with abrasive powders or with chemical agents such as benzene or thinner.
• Use only the correct Panasonic handset.
• Do not disassemble this unit. Dangerous electrical shock could result.
The unit must only be disassembled and repaired by qualified service technicians.
• If damage to the unit exposes any internal parts, immediately disconnect the cable or cord.
• Never attempt to insert wires, pins, etc. into the vents or other holes of this unit.
• This unit is designed to aid the visually handicapped to locate dial keys and buttons.
• This unit is designed to be installed under controlled conditions of ambient temperature and a relative humidity.
• Avoid installing the unit in damp or humid environments, such as bathrooms or swimming pools.
• 999 and 112 can be dialled on the product after accessing the outside line for the purpose of making outgoing calls to the BT emergency (999) and (112) services (United Kingdom only).
14
Important Information
Take special care to follow the safety suggestions listed below.
Installation
Environment
1) Do not use this unit near water, for example, near a bathtub, washbowl or sink. Damp basements should also be avoided.
2) Keep the unit away from heating appliances and devices that generate electrical noise, such as fluorescent lamps, motors, and televisions.
These noise sources can interfere with the performance of the unit. It also should not be placed in rooms where the temperature is less than
5 °C or greater than 40 °C.
Placement
1) Do not place heavy objects on top of this unit.
2) Care should be taken so that objects do not fall onto, and liquids are not spilled into, the unit. Do not subject this unit to excessive smoke, dust, moisture, mechanical vibration, shock, or direct sunlight.
3) Place the unit on a flat surface.
WARNING:
TO PREVENT POSSIBLE FIRE OR ELECTRIC SHOCK, DO NOT
EXPOSE THIS UNIT TO RAIN OR MOISTURE.
THIS HANDSET EARPIECE IS MAGNETISED AND MAY RETAIN SMALL
FERROUS OBJECTS.
THE USE OF EXCESSIVE SOUND VOLUME THROUGH EARPHONES,
HEADPHONES, OR HEADSETS MAY CAUSE HEARING LOSS.
DISCONNECT THE TELEPHONE LINE CORD FROM THIS PRODUCT IF
THIS PRODUCT EMITS SMOKE, AN ABNORMAL SMELL OR MAKES
UNUSUAL NOISE. THESE CONDITIONS CAN CAUSE FIRE OR
ELECTRIC SHOCK. CONFIRM THAT SMOKE HAS STOPPED AND
CONTACT AN AUTHORISED SERVICE CENTRE.
IMPORTANT NOTICE:
• Under power failure conditions, the DPT may not operate. Please ensure that a separate telephone, not dependent on local power, is available for use in remote sites in case of emergency.
This unit is capable of being used in conjunction with hearing aids fitted with inductive coil pick-ups. The handset should be held as for normal conversation. For operation, the hearing aid should be set to its "T" position or as directed in the operating instructions for the hearing aid.
15
Important Information
Information for Users on Collection and Disposal of Old
Equipment and used Batteries
These symbols on the products, packaging, and/or accompanying documents mean that used electrical and electronic products and batteries should not be mixed with general household waste.
For proper treatment, recovery and recycling of old products and used batteries, please take them to applicable collection points, in accordance with your national legislation and the
Directives 2002/96/EC and 2006/66/EC.
By disposing of these products and batteries correctly, you will help to save valuable resources and prevent any potential negative effects on human health and the environment which could otherwise arise from inappropriate waste handling.
For more information about collection and recycling of old products and batteries, please contact your local municipality, your waste disposal service or the point of sale where you purchased the items.
Penalties may be applicable for incorrect disposal of this waste, in accordance with national legislation.
For business users in the European Union
If you wish to discard electrical and electronic equipment, please contact your dealer or supplier for further information.
Information on Disposal in other Countries outside the European Union
These symbols are only valid in the European Union. If you wish to discard these items, please contact your local authorities or dealer and ask for the correct method of disposal.
Note for the battery symbol (bottom two symbol examples):
This symbol might be used in combination with a chemical symbol. In this case it complies with the requirement set by the
Directive for the chemical involved.
16
Important Information
This product is intended to be connected to a Panasonic PBX only.
Panasonic Communications Company (U.K.) Ltd. declares that this equipment is in compliance with the essential requirements and other relevant provisions of Radio & Telecommunications Terminal Equipment
(R&TTE) Directive 1999/5/EC.
Declarations of Conformity for the relevant Panasonic products described in this manual are available for download by visiting:
http://www.doc.panasonic.de
Contact to Authorised Representative:
Panasonic Testing Centre
Panasonic Marketing Europe GmbH
Winsbergring 15, 22525 Hamburg, Germany
17
Notes
Notes
18
WALL MOUNTING TEMPLATE
1. Drive the screws into the wall
as indicated.
2. Hook the unit onto the screw
heads.
Note:
Make sure to set the print size to
correspond with the size of this
page. If the dimensions of the
paper output still deviate slightly
from the measurements indicated
here, use the measurements
indicated here.
One screw here
One screw at either point
19
Panasonic Business Systems U.K.
Panasonic House, Willoughby Road, Bracknell,
Berkshire RG12 8FP
Copyright:
This material is copyrighted by Panasonic Communications Co., Ltd., and may be reproduced for internal use only. All other reproduction, in whole or in part, is prohibited without the written consent of Panasonic Communications
Co., Ltd.
© Panasonic Communications Co., Ltd. 2008
PSQX4692ZA-UF
KK0908YH0 (UK)
