DSC POWER SERIES BASIC FUNTIONS
ARMING IN STAY MODE: With the green ready light on (all zones closed) press an hold STAY until it
beeps. Motion detectors will automatically be bypassed.
ARMING IN AWAY MODE: With the green ready light on (all zones closed) press and hold AWAY until
it beeps. Entire system is armed.
BYPASSING ZONES: Press *1 then enter the zone to be bypassed (in 2 digit format ie. 01) followed
by #.
CHIME FEATURE: To activate or deactivate the chime feature, press and hold CHIME until it beeps.
EXIT BUTTON: When the system is armed you can press and hold EXIT button until it beeps. It will
then allow you exit & re-enter the premises within a two minute period.
INSTANT ARMING: Press *9 followed by the master code. This arms the system in STAY mode but
removes the delay on entry doors (will not give time to enter code before alarm sounds.)
ALARM MEMORY: Pressing *3 will display the alarm memory during the last armed period. This
memory will be cleared the next time the system is armed.
FIRE ALARM: If your system is equipped with smoke detectors to reset them press and hold RESET
until it beeps or press *72.
TROUBLE LIGHT: If the trouble light is on pressing *2 will silence the trouble beep and display one or
more zone indicators which correspond to the type of system trouble. See below.
o Zone 1 – Service required:
Press 1 again to determine the service needed:
1. Low system battery.
2. Bell circuit trouble.
3. General System trouble.
4. General System tamper.
5. General System supervisory.
6. PC5204 low battery.
7. PC 5204 AC failure.
Zone 2 – AC Failure (No main power – system running on battery.)
Zone 3 – Telephone line trouble. Phone service is interrupted –panel cannot call out.
Zone 4 – Panel failed to send central station a signal
Zone 5 – Zone fault – Press 5 to determine which zone is faulted.
Zone 6 – Zone tamper – Applies to wireless zones. Press 6 to see which zone.
Zone 7 – Low zone battery – Applies to wireless zones. Press 7 for zone.
Zone 8 – Loss of system time. See instructions below.
*6, master code, 1 enter time in 24hr format and date mm/dd/yy. Press #
when finished. (Example: 2:32pm on 7/04/12 *6, master code, 1, 1432, 070412 #)
CHANGE MASTER CODE: *5, current master code, 40, new master code (4 digits) # #
USER CODES: *5, master code, user code position no. (01-32), new user code (4 digits) # #
ERASE USER CODE: *5, master code, user code position no. (01-32), * # #
DURESS CODE: *5, master code, 33, duress code (4 digits), # #
TEST SIGNAL: *6, master code, 4 –siren will sound, lights on keypad will flash # # Send a test
RESET SYSTEM TIME:
signal at least monthly.
FACTORY DEFAULT MASTER CODE IS 1234
">
