Waves System Module 2, SP603, SP703 Audio System Components Installation Guide

I.D.AL - Standalone MP3 player - Module 2 for SP603/SP703 - Ethernet option - Installation
SP603
SP703
Module 2
Installation
(Ethernet)
Bill of material :
- 1 x Ethernet Board
- 1 x RJ45 mounting connector
- 1 x RJ45 cable 60cm
- 1 x RS232 cable 4pts
- 1 x I/O cable 2pts
- 1 x Modem cable 10pts
- 2 x threaded spacer M3x20
- 2 x Screw M3x6
- 2 x plastic coller
Date : December 2005
® Waves System
La Ville en Bois
44830 BOUAYE - FRANCE
Tel : +33 (0)2 40 78 22 44
Fax : +33 (0)2 40 78 00 36
E-mail : [email protected]
V 1.0 - 2005
I.D.AL - Standalone MP3 player - Module 2 for SP603/SP703 - Ethernet option - Installation
Module 2 installation :
●
●
1 - Remove the top cover to open up the player. Caution with the ground cable.
2 - Locate the motherboard and the rippon cable.
Ribbon cable
Motherboard
Ground cable
3 - Disconnect the ribbon cable
from the motherboard.
●
4 - Remove the 2 nuts and screw
the 2 threaded spacer supplied.
● 5 - Connect the Ethernet card
to the ribbon cable.
●
6 - Connect the Ethernet card
on the motherboard. Be careful,
there are 2 connectors : a large
one with 40 pins and a small one
with 2 pins.
●
® Waves System
● 7 - Fasten the Ethernet
card with the 2 screws
supplied.
V 1.0 - 2005
I.D.AL - Standalone MP3 player - Module 2 for SP603/SP703 - Ethernet option - Installation
● 8 - Remove the rear cover of the initial module
of the player by pivoting it from top to bottom.
9 - Insert the RJ45 mounting connector
from the inside.
●
10 - Connect the RJ45 cable onto the connector
then onto the Ethernet card connector.
●
11 - Disconnect the RS232 cable
(grey ribbon cable with 4 wires)
from the mortherboard and
connect it onto the Ethernet card.
●
● 12 - Connect the cable
supplied to the motherboard on
one side and the Ethernet card
on the other side.
13 - Connect the I/O cable between the
Ethernet card and the motherboard. Be careful
of the way the connector is installed on the
motherboard !
●
Black wire
Red wire
1
2
3
4
Black wire
Red wire
® Waves System
V 1.0 - 2005
I.D.AL - Standalone MP3 player - Module 2 for SP603/SP703 - Ethernet option - Installation
14 - Connect the Modem cable between the
Ethernet card and the output module.
●
●
15 - Close the top cover. The player is ready.
http://www.wsystem.com
ID-AL Players dedicated web site :
http://www.id-al.com
® Waves System
V 1.0 - 2005
">