HUAWEI SmartAX MT882 ADSL router configuration

HUAWEI SmartAX MT882 ADSL router configuration guide

Physical Outlook

Front Panel - LED Indicators

The ADSL Router is equipped with four LEDs on the front panel as described in the table below

Name of LED Favarouble

PWR

Indication

Green

Description

The Power LED lights up when the router is powered on

Link Red This LED becomes RED if router got IP address

solid Green shows router trained waiting to get

IP address

ACT

LAN

USB

Green,blinking Indicates Data transfer

Green/Red

Green

Solidly lit when Ethernet connection to PC is OK

Solidly lit when USB connection to PC is OK

Configuration

1) Open the Internet Explorer and type http://192.168.1.1/ Then the following window will appear

2) Type username as admin and password as admin

Then the following window will appear

If you are configuring the router for the first time, please go through Note 1 before further proceddings

3) Click on ATM setting

4) Select PVC as 0

Type VPI 0 VCI 32

Mode Routing

Servicename mtnl

Type Telephone no as username, C.A No (Subscriber No) as password

Select Default Route Enable

Click Apply

5) To save the configuration,go to Restart , Select current settings, Click Restart

6. At the time of restarting again the following window will appear.

Please enter the username & password as “admin”

Now the configuration is over

To check whether router got Connected or not

Open router homepage, ( http://192.168.1.1/ ) If on the PVC 0 row,IP address is got, indicates connectivity of router to the Internet.

Note 1

By default, VPI 0 & VCI 32 is configured for PVC 2; So you are advised to change VCI on PVC 2 as 60 (or anything different from configured VCIs)

To achieve this,go to ATM settings Select PVC as 2 , Select VCI 60 Click Apply

(This is required for router configuration on the first time because router is to be configured on PVC 0 and VPI 0 & VCI 32)

Note 2

At the time of installation, if router IP ( http://192.168.1.1/ ) is not pinging, and IP address is not getting after doing 'ipconfig' command enter the following details on the TCP/IP properties of Network Adapter (LAN card/USB)

IP address: 192.168.1.2

Subnetmask : 255.255.255.0

Default Gateway: 192.168.1.1

Primary DNS server: 203.94.227.70

Alternate DNS server : 203.94.243.70

This happens when DHCP server is disabled by default; So to enable this,

Go to other Setting --> DHCP mode

Select DHCP as server

Enter Client IP Pool starting address as 192.168.1.2

Enter Primary DNS server: 203.94.227.70

Secondary DNS server : 203.94.243.70