Lindy 32629 video converter User manual

Introduction
Thank you for purchasing the LINDY Composite/S-Video to VGA
Converter. This video converter will allow you to connect your SVideo or Composite Video source to a VGA Type Display with
resolutions up to 1600 x 1200. This is ideal for Gaming or Home
Cinema applications.
Video to VGA Converter
System Requirements
Video source with either an S-Video or Composite video
output connection
User Manual
English
XGA, SXGA, UXGA Compatible display device
Package Contents
1 x Video to VGA Converter
5v DC Switch Mode PSU rated equal to 1 Amp or greater
This User Manual
LINDY No. 32629
www.lindy.com
Product Information
Operates in NTSC 3.58 and PAL Display Systems
Operation Control and Functions
Top Panel
Motion adaptive 3D Y/C separation comb filter (for
Composite video input)
3D (frame based) motion adaptive YNR/CNR noise
reduction (for Y/C video input)
Advance 3D motion adaptive de-interlace
Automatic 2:2 & 3:2 film mode detection
50/60Hz frame rate conversion
High-resolution VGA output
Plug & play - No driver software required, easy to
install
Compact size
1. The Input selection switch toggles between Composite
and S-Video input
2.
The LED indicator shows which input signal is selected
• Green LED - Composite input signal
• Red LED - S-Video input signal
Front & Rear Panel
1. S-Video input
2. Composite video input
3. DC power supply input
4. Output resolution selection switch at 60Hz vertical rate
Product Specifications
•
• XGA 1024 x 768
Video Input Connectors:
• SXGA 1280 x 1024
Composite Video (RCA/Phono socket) 75 Ohm
• UXGA 1600 x 1200
S-Video (4 Pin Mini-Din) 75 ohm
•
5. VGA output
Video Output connectors:
• HD-15 Female connector
•
15-Way HD VGA Female
Output resolutions:
Typical Installation
XGA:
1024 x 768 @ 60Hz
SXGA:
1280 x 1024 @ 60HZ
UXGA:
1600 x 1200 @ 60Hz
•
Power: DC 5V 1.5A, centre positive
•
Dimensions: 153 x 122 x 57mm (WxDxH)
XGA/SXGA/UXGA Display
Composite or S-Video in
Certifications
CE Statement
This device complies with the European Regulations for Electromagnetic
Compatibility (EMC) of the European Union and it is equipped with the
CE mark. This unit has to be used with high quality shielded connection
cables. Only if these high quality shielded cables are used it can be sure
that the EMC compatibility is not adversely influenced.
FCC Statement
Shielded cables must be used with this equipment to maintain
compliance with radio frequency energy emission regulations and ensure
a suitably high level of immunity to electromagnetic disturbances.
FCC Warning
This equipment has been tested and found to comply with the limits for a
Class B Digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference
to radio communications.
However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected
Consult the dealer or an experienced technician for help
You are cautioned that changes or modifications not expressly approved
by the party responsible for compliance could void your authority to
operate the equipment.
WEEE (Waste of Electrical and Electronic Equipment),
Recycling of Electronic Products
In 2006 the European Union introduced regulations (WEEE) for the
collection and recycling of all waste electrical and electronic equipment.
It is no longer allowed to simply throw away electrical and electronic
equipment. Instead, these products must enter the recycling process.
Each individual EU member state has implemented the WEEE
regulations into national law in slightly different ways. Please follow your
national law when you want to dispose of any electrical or electronic
products.
More details can be obtained from your national WEEE recycling
agency.
Germany / Deutschland:
Die Europäische Union hat mit der WEEE Direktive umfassende
Regelungen für die Verschrottung und das Recycling von Elektro- und
Elektronikprodukten geschaffen. Diese wurden von der Bundesregierung
im Elektro- und Elektronikgerätegesetz – ElektroG in deutsches Recht
umgesetzt.
Dieses Gesetz verbietet vom 24.März 2006 an das Entsorgen von
entsprechenden, auch alten, Elektro- und Elektronikgeräten über die
Hausmülltonne! Diese Geräte müssen den lokalen Sammelsystemen
bzw. örtlichen Sammelstellen zugeführt werden! Dort werden sie
kostenlos entgegen genommen. Die Kosten für den weiteren
Recyclingprozess übernimmt die Gesamtheit der Gerätehersteller.
LINDY No. 32629
www.lindy.com
nd
2 Edition March 2011