Installation Guide
Case components
120 mm fan
Ventilation holes in the PCI slots
Removable
PSU bracket
3.5" HDD cage for 3.5" HDD x 10
(Hot swap x 2)
120 mm fans x 3
Removable air filter
Dual LED
Power switch
(Blue LED for power)
(Red LED for HDD)
Multi-media ports
Female clip
2.5" HDD mount
Hardware list
Buzzer (1)
Screws M3*9.5 (5) for 2.5" HDD
Cable ties (1)
Anti-vibration rubber rings (5) for 2.5" HDD / 3.5" HDD
Anti-vibration silica gel rings (44) for 3.5" HDD
Remove side panels Remove air filters Motherboard installation
Thumb screws (44) for 3.5" HDD
Screws (5) for M/B
Removing fan modules
Extra quantities are spare parts.
Screws (5) for PSU mounting
Clamp (2)
Push to release.
Pull side panel out to remove.
2.5" HDD installation
Reserved hole for installation 120 mm fan
(Fan is not included)
Place the M/B onto the copper bolt and fasten screws to secure.
Slide the anti-vibration fan sideways to remove.
3.5" HDD installation-1 (hot swap)
Install screws along with anti-vibration rubber rings onto the HDD.
Slide the HDD into the holes on the HDD platform.
PSU installation
Install screws along with anti-vibration silica gel rings onto the 3.5" HDD.
Slide the HDD into the
HDD cage.
Close the gate to secure the HDD.
Cable management
Loose 4 thumb screws to remove the PSU mounting bracket.
I/O port installation
HD AUDIO
BLUE 10
BLACK PURPLE
YELLOW
GRAY
RED
4
2
8
6
9
3
1
7
5
GREEN
KEY
ORANGE
N.C.
GND+H.S. TUBE
Assembly power supply with
PSU mounting bracket.
Push in gently.
USB 3.0
11 10
Supports motherboard
USB 3.0 20 Pin header
20 1
Fasten 4 thumb screws to secure.
Press to release.
Cable installation guide
BLACK / WHITE
BLACK
POWER SW
BLACK / WHITE +
BLACK -
POWER LED
POWER LED
BLACK / WHITE -
BLACK +
RED+
NC
NC
Blue
HDD LED
SPEAKER
C50.Q2600.00E
