Features: Operation
The ST4002 and ST4003 Desktop Docking Stations feature:
- Fast charging of the Omnii™ internal battery.
- Fast charging of the spare battery pack.
- A Host USB port to connect peripherals such as a printer, keyboard, etc.
- A Client USB port to connect the docking station to a PC.
The ST4003 Desktop Docking Station additionally provides:
- A DE9M serial port (unpowered).
- An RJ45 10Base-T Ethernet interface. Both these interfaces are compatible with the
USB to Ethernet/serial drivers included in Omnii™.
Features: Front
Spare battery well
Omnii™ compartment
Docking connector
Release button
Locking arm
LED indicator
8000203A.indd 1
Features: Back and Battery Charge Well
Docking connector
Omnii™ compartment
GETTING STARTED
1 Choose a plug for the universal power adaptor. The adaptor may already be fitted with the plug you need.
1. Press the button on the power adaptor to release the plug.
2. Slide the existing plug out of the adaptor.
Battery connector
Spare battery charge well
Features: Rear Ports
ST4002
DC In port
ST4003
.
3. Slide the desired plug into the adaptor until it clicks.
2 Connect the Docking Station to external power.
Host USB port Client USB port Host USB port
DE9M Serial port
Client USB port
RJ45 Ethernet port DC Input
3 Insert the hand-held to charge its battery.
Slide the hand-held computer into the Docking Station until it latches.
4 Insert the spare battery.
Place the battery contacts down to mate with the connector, and pivot the battery into place in the battery charge well.
Note:
Use only the universal AC power supply approved by Psion
Teklogix for use with the Docking Station.
- During charge, the LED indicator on the
hand-held flashes GREEN.
- When finished charging, the indicator
displays solid GREEN.
- The LED indicator on the Docking Station
behaves the same when a spare battery
is being charged.
5 Allow the hand-held computer and the spare battery to charge for three hours before first use.
0 - 40 °C
32 - 104 °F 3 h
Note: Full battery performance is only reached after the first few charge/discharge cycles.
Over
7/19/2010 4:44:47 PM
Docking Station Battery Charge LED Behaviour
Charge LED Behaviour Function
OFF
Solid Green
No battery detected.
Battery charging complete.
Flashing Green
Flashing Yellow
Solid Red
Charge in progress.
Battery is not charging due to out-of-temperature conditions.
Unable to read battery or non Psion Teklogix battery.
To connect the Docking Station to a host computer:
The hand-held computer in the Docking Station acts as a USB Client.
1. Connect the smaller end of the USB cable to the Docking Station (ST4002 shown).
2. Connect the flat end of the USB cable to the host computer.
Contents of the Box:
The Docking Station
USB Micro-B to Type A cable
Quick Start Guide
Omnii™ Desktop Docking Stations
ST4002 and ST
4003 t System
This Guide
Power adaptor and plugs USB Host computer
8000203A.indd 2
Quick Start Guide
Omnii™ Desktop Docking Stations
ST4002 and ST4003
July 19, 2010 PN 8000203.A
Psion Teklogix and Omnii are a trademarks of Psion
Teklogix Inc. Other product names mentioned in this document are trademarks or registered trademarks of other hardware, software, or service providers and are used herein for identification purposes only.
8 0 0 0 2 0 3
Rev. A
ISO 9001 Certified
Quality Management System
7/19/2010 4:44:50 PM
