Nisca Encoder Unit Manual

Installation of the Encoder Unit
Step 1
Step 2
Step 3
Step 4
Turn OFF the printer power source.
Remove RIGHT -COVER. ( Remove 2 x M-4 screws )
Take the screw off to take out a slide for a card rejected .
Insert the ENCODER into the encoder space of the printer with connecting the
two harnesses from the printer.
Step 5 Fix the ENCODR with the screw of which was removed in Step3.
Step 6 Put the small Exsit Cover on the RIGHT -COVER with two screws.
The Exit Cover and two screws are supplied with ENCODER.
Step 7 Put the RIGHT-COVER back to the printer and fix with 2 x M-4 screws
Step 3
Step 5
Step 4
Step 6
">