Items
Description
1.
Power OFF
Turns the projector off
2.
HDMI 2
Displays the HDMI 2 source selection
3.
PC
Displays the PC source selection
4.
VIDEO
Displays the VIDEO source selection
Up cursor/Keystone +
Navigates and changes settings in the OSD
Quick Menu – For Keystone
6.
ENTER
Enters and confirms settings in the OSD
7.
Right cursor
Navigates and changes settings in the OSD
8.
Down cursor
9.
ASPECT RATIO
Displays the ASSPECT RATIO selections
10.
SOURCE
Detects the input device
11.
2D „ 3D
Toggle 3D function
12.
BRIGHT
Displays the brightness setting bar
13.
SHARP
Displays the sharpness setting bar
14.
COLOR
Displays the color setting bar
15.
TINT
Displays the tint setting bar
16.
BLANK
Makes the screen blank
17.
FREEZE
Freezes/unfreezes the on-screen picture
AUTO
Auto adjustment for frequency, phase, and
position
LIGHT
Turns on or off the remote control backlight
for about 10 seconds. Pressing any other key
while the backlight is on keeps the backlight
on for a further 10 seconds.
20.
VOL -
Adjust the volume of the audio out
21.
VOL +
22.
MUTE
Mutes the audio out
23.
CONTRAST
Displays the contrast settings bar
24.
PICTURE MODE
Changes the Display Mode setting
25.
MENU/EXIT
Opens and exits the OSD
26.
Left cursor
Navigates and changes settings in the OSD
27.
COMP
Displays the Component source selection
28.
HDMI 1
Displays the HDMI 1 source selection
29.
Power ON
Turns the projector on
30.
IR transmitter
Transmits signals to projector
5.
18.
19.
Quick Start Guide
The Remote Control Functions
CRYSTALcube
The Remote Control
www.sim2.com
Quick Start Guide
CRYSTALcube
1. Connect Power
3. Power On & Select Source
5. Adjust Zoom & Focus
Focus
~1
Zoom
0V
-24
00
IN
AC
1
2.Connect Input Device(s)
To The Projector
4. Projector positioning
For ceiling mounting instructions, please see the Crystal Cube Installation Guide and User Manual available at www.sim2.com
6. Ready! Set! Action!
">
