Thank you for purchasing this PENTAX digital camera.
The PENTAX WG-10 is waterproof, dustproof, and shockproof, as shown below, so you can use it in a wide range of outdoor activities.
Waterproof/dustproof: JIS grade 8 waterproof and grade 6 dustproof (IP68)
Shockproof: Satisfies PENTAX drop test (1.5 m height onto a 5 cm thick plywood surface) complying with
MIL-Standard 810F Method 516.5-Shock testing.
* Waterproof performance is not guaranteed if the camera is exposed to impact such as being dropped or hit.
* The camera is not guaranteed to be free of trouble or damage under every condition.
1 1
Preparing the Camera for Use
Prepare your camera for use before you begin using it.
Attaching the
Strap
Attach the strap supplied with the camera as shown in the illustration.
Installing the Battery and SD Memory Card
Install the battery and SD
Memory Card as shown in the illustration.
Battery/ card cover
Battery/card cover lock lever
SD Memory Card socket
SD Memory Card
Battery lock lever
Battery
* The SD Memory Card is sold separately.
The inside of the battery/card and terminal covers are not waterproof
In locations where the camera is exposed to water or dirt such as underwater, at the beach, in a kitchen, etc., make sure that the battery/card and terminal cover lock levers are firmly locked so that they won't open unexpectedly. Do not open the covers in such locations.
When removing the battery or card, avoid surroundings where the camera may be exposed to water or dirt, and make sure the camera, battery, card, and your hands are completely dry.
2012/12/14 11:41:28 Illustrator 15.0.2 KB546_QG_EN_Omote_10e.eps
Checking the Contents of the Package
Check that your camera comes complete with the items listed below.
Camera (PENTAX WG-10) Software (CD-ROM)
S-SW136
USB cable (I-USB7)
Battery charger (D-BC92) AC plug cord
Strap (O-ST104)
Operating Manual
Rechargeable lithium-ion battery (D-LI92)
Macro stand (O-MS1)
Quick Guide (this guide)
Names of Parts and Monitor Indicators
Front Shutter release button
Power switch/Power lamp (green)
Back
Macro light
Terminal cover lock lever
Terminal cover
Flash
Lens
Speaker/Microphone
Remote control receiver
Self timer lamp/
Focus assist
Display
Tripod socket
Battery/card cover lock lever
Battery/card cover
PC/AV terminal HDMI terminal
In this Quick Guide, the arrow keys to be pressed are indicated as shown on the right.
4
2
5
3
Battery lock lever
Monitor Indicators
Following indicators are displayed in the still picture capture mode.
Normal display in the Still Picture Capture Mode
Drive mode
Flash mode
Shooting mode
Battery level
Face Detection
Date imprint setting
EV compensation
Shutter speed
Aperture
Camera shake reduction
Memory status
Focus mode
P
DATE
+1.0
1/250
F3.5
38
Eye-Fi communication status
Digital zoom icon
Built-in memory
(without card)
SD Memory Card
Card is write-protected
Focus frame
D-Range Setting
World Time setting
Remaining image storage capacity
Date and time
No icon Hometown
: Destination
Battery Level Indicator
You can check the battery level by the indicator on the display.
Screen Display
(green)
(green)
(yellow)
(red)
[Battery depleted]
Battery Status
Adequate power remains.
Battery is running low.
Battery is running very low.
Battery is exhausted.
The camera turns off after this message appears.
Turning the Camera On
Press the power switch.
The camera turns on and is ready to take still pictures. Press the power switch again to turn the camera off.
Make the Initial Settings.
The [Language/ ] screen appears when the camera is turned on for the first time. Select the desired language and then set the date and time.
1
Use the four-way controller
( 2345 ) to select the desired language.
2 Press the 4 button.
The [Initial Setting] screen appears.
MENU Cancel OK OK
Memo
If you accidentally select the wrong language and press the 4 button, press the four-way controller ( 5 ), use the four-way controller ( 2345 ) to select the desired language, and then press the 4 button. The [Initial
Setting] screen appears in the selected language.
Initial Setting
English
Hometown
New York
Settings complete
DST
MENU Cancel
3 Press the four-way controller ( 3 ) to move the frame to [W Hometown].
Initial Setting
English
Hometown
New York
Settings complete
DST
MENU Cancel
4 Press the four-way controller ( 5 ).
The [W Hometown] screen appears.
Hometown
City
DST
MENU Cancel
New York
5 Use the four-way controller ( 45 ) to choose a city.
6 Press the four-way controller ( 3 ) to move the frame to [DST]
(Daylight Saving Time).
OK OK
7 Use the four-way controller ( 45 ) to select O or P and press the 4 button.
The [Initial Setting] screen reappears.
8 Press the four-way controller ( 3 ) to select [Settings complete] and press the 4 button.
The [Date Adjustment] screen appears.
9 Press the four-way controller
( 5 ) to select [mm/dd/yy], then use the four-way controller
( 23 ) to choose the date format.
Date Adjustment
Date Format
Date
Time mm/dd/yy 24h
01/01/2013
00:00
Settings complete
MENU Cancel
10 Press the four-way controller ( 5 ) to select [24h], then use the four-way controller ( 23 ) to select [24h] (24-hour display) or [12h] (12-hour display).
11 Press the four-way controller ( controller (
5 ), then press the four-way
3 ) to move the frame to [Date].
12 Press the four-way controller ( 5
(day) or [2013] (year), then use the four-way controller ( to set the current date and time.
) to select [01] (month), [01]
23 )
13 Press the four-way controller ( controller (
5 ), then press the four-way
3 ) to move the frame to [Time].
14 Set the time in the same manner as in . Then press the four-way controller ( 5 ).
12
15
Press the four-way controller ( 3 ) to select [Settings complete] and press the 4 button.
Date Adjustment
Date Format
Date
Time mm/dd/yy 24h
01/01/2013
00:00
Settings complete
MENU Cancel OK OK
Formatting an SD Memory Card
Use this camera to format (initialize) an SD Memory Card that is unused or has been used on another camera or digital device.
Be aware that formatting will delete all the data stored in the SD
Memory Card. For how to format an SD Memory Card, refer to the Operating Manual (p. 214).
Continue on the reverse side.
Taking Pictures
Aim the camera at the subject, then press the shutter release button. The flash discharges automatically depending on the brightness.
1 Frame the subject using the focus frame on the display.
2 Press the w/xbutton to change the captured area.
Widens the area that is captured by the camera
Enlarges the subject
3 Press the shutter release button halfway.
The focus frame on the display turns green if the subject is in focus.
4 Press the shutter release button fully.
The picture is taken.
1/250
F4.6
38
Selecting the Flash Mode
Each time you press the four-way controller ( 4 ), the flash mode switches between the following modes.
Auto
Flash Off
Flash On
Auto + Red-eye
Flash On + Red-eye
Memo
The functions available in Capture mode may be different.
For details, refer to the Operating Manual (p.108).
Selecting the Drive Mode
Each time you press the four-way controller ( 2 ), the drive mode switches between the following modes.
Standard (single-frame)
10 sec. Self-timer
3-sec Remote Control
Memo
The functions available in Capture mode may be different.
You can select controller (
Z (2 sec. Self-timer) by pressing the four-way
3 ) and then ( 5 ) after selecting g (10 sec. Self-timer).
You can select controller ( h (0-sec Remote Control) by pressing the four-way
3 ) and then ( 5 ) after selecting i (3-sec Remote
Control).
For details, refer to the Operating Manual (p.94 - 101).
Selecting the Focus Mode
Each time you press the four-way controller ( ), the focus mode switches between the following modes.
Standard
Macro
1cm Macro
Pan Focus
Infinity
Manual Focus
Memo
For details, refer to the Operating Manual (p.110).
Selecting a Shooting Mode
You can choose the right mode for your particular situation from the Capture Mode Palette.
Press the four-way controller ( 3 ).
Landscape 1/2
For capturing landscape views. Enhances colors of sky and foliage
MENU Cancel OK OK
Use the four-way controller ( 2345 ) to choose a shooting mode, then press the OK button.
Memo
An explanation appears when you select the shooting mode.
The monitor display in 16:9 aspect ratio
When [Recorded Pixels] is set to i / / / h in [A Rec. Mode], the aspect ratio of the image is 16:9 and the monitor display for recording and playback is as shown below.
For details on how to select the Recorded Pixels, refer to the
Operating Manual (p.116).
P
4
Playing Back Images
You can play back the images taken on the display.
Playing Back Images
1 Press the Q button after taking a picture.
The image appears on the display.
1 Play back the image you want to delete.
2 Press the i button.
The confirmation screen appears.
3 Use the four-way controller ( 2 ) to select [Delete].
Delete
Cancel
Edit
Memo
To play back the previous or next image, press the four-way controller ( 45 ).
Pressing f on the f/y button during playback displays 6 thumbnail images. Pressing f again in 6-image display switches to 12-image display. Pressing f yet again switches to folder or calendar display. For details, refer to the Operating Manual
(p.153).
Deleting Images
Deleting a Single Image
You can delete the currently displayed image.
4 Press the OK button.
Memo
You can delete several images selected from the 6- or 12-image display. For details, refer to the Operating Manual (p.167).
You can delete all images at once. For details, refer to the
Operating Manual (p.168).
You can protect stored images from being accidentally deleted.
For details, refer to the Operating Manual (p.169).
2012/12/18 10:52:43 Illustrator 15.0.2 KB546_QG_EN_Ura_CS5e.eps
Selecting a Playback Mode
You can choose the playback function you want to use with the Playback
Mode Palette.
Press the four-way controller ( 3 ) while an image is displayed in playback mode.
Slideshow 1/2
For continuously playing back images. Screen or sound effects can be set
MENU Cancel OK OK
Use the four-way controller ( 2345 ) to choose a playback mode, then press the OK button.
Memo
An explanation appears when you select the playback mode.
For details about how to use the PENTAX
WG-10 or instructions on connecting the camera to a computer, refer to the manual below.
PENTAX WG-10
Operating Manual
PENTAX RICOH IMAGING CO., LTD.
http://www.pentax.jp
PENTAX RICOH IMAGING FRANCE S.A.S.
(European Headquarters)
HQ
France http://www.pentax.eu
http://www.pentax.fr
PENTAX RICOH IMAGING DEUTSCHLAND GmbH http://www.pentax.de
PENTAX RICOH IMAGING UK LTD.
http://www.pentax.co.uk
PENTAX RICOH IMAGING
AMERICAS CORPORATION http://www.pentaximaging.com
PENTAX RICOH IMAGING CANADA INC.
http://www.pentax.ca
PENTAX RICOH IMAGING CHINA CO., LTD.
http://www.pentax.com.cn
54768
Printed in Indonesia R01BAA13
