Intel ETHEREXPRESS PRO/100 Quick Start Card

Q u i c k S t a r t C a r d

EtherExpress

™

PRO/100 Mobile PC Card

Use these instructions to install the PRO/100 PC Card under Windows 95*

Windows 98*, Windows for Workgroups, or Windows NT*. For MS-DOS without Windows , see Chapter 2, Software Installation in the User’s Guide.

1. Windows 95 / 98

Start your computer first and let

Windows 95 /98 run. With the

Intel logo on top and the arrow on the label facing into your computer, insert the card in a PC

Card (PCMCIA) slot. Push until the card is firmly seated. Go to step 2.

➊

™

ATTACH THE ADAPTER

CABLE TO THE CARD

➋

1. Windows 3.x

Do not start your computer. With the Intel logo on top and the arrow on the label facing into your computer, insert the card in a PC

Card (PCMCIA) slot. Push until the card is firmly seated.

➌

CONNECT THE NETWORK

CABLE TO THE ADAPTER

CABLE

2. Attach adapter cable to card

As shown, attach the adapter cable to the card and push in lightly. Note position of Intel logo.

3. Connect network cable to adapter

As shown, attach the network cable RJ-45 connector to the PRO/100 PC Card

RJ-45 cable receptacle.

668560-003

4. Install the drivers for your operating system

Windows 95/98: See section below.

Windows 3.x and Windows for Workgroups: See section below.

Windows NT 4.0: Choose Control Panel, Network, Adapters, Add, and Have

Disk. Insert the Intel Network Drivers Disk and click OK. Click Close to finalize the installation. Restart the computer when prompted.

Windows 95/98 Driver

• If Windows 95/98 detects the PRO/100 PC Card, proceed to the next bullet point. If Windows 98 does not detect the PC Card, see the README.TXT

file for instructions on manually adding a PC Card. If Windows 95 does not detect the PC Card, first click on the PC Card (PCMCIA) icon in the Control

Panel to enable PC Card services, then go to the next bullet point.

• If prompted for a manufacturer’s disk, insert the Network Drivers Disk and follow the instructions on screen. Restart the computer when prompted.

Windows 3.x and Windows for Workgroups:

Run the Intel Installation program to install drivers

• Start computer and Windows OS.

• Insert Disk 1, Installation Disk, into your diskette drive.

• From the Program Manager, choose File/Run. In the Command Line box, type A:SETUP. Press Enter or click OK.

• Highlight your network operating system and click OK.

• Complete the steps prompted by the Installation Program, then proceed to

Chapter 2, Software Installation in the User's Guide. Find your network operating system in the alphabetical listing under Installing

Network Software in Chapter 2. Follow the procedures shown to complete the installation. If prompted for a manufacturer’s disk, insert disk 2, Network Drivers Disk.

Copyright © 1998, Intel Corporation. All rights reserved. Intel Corporation assumes no responsibility for errors or omissions in this document. Nor does Intel make any commitment to update the information contained herein. * Other product and corporate names may be trademarks of other companies and are used only for explanation and to the owners’ benefit, without intent to infringe.