Home Decorators Collection 8188010280 Installation Guide

HDC#: 8188010280 MFG#: PBW-3568-5880

Please read over the instructions, it will be a time-saver in the long run.

Mounting Screw

Glass shade

J

Decorative ring

Socket Ring 1

J

1.

2.

Pull out all wires(White, Black, and Ground) out of junction box.

Unscrew Compression Nut(F) from Canopy (E) and slide Canopy (E) down cord, Then unscrew Finial Nut(D) from the Crossbar(A). and slide the Crossbar(A) to suitable place to

3.

ease installation of Crossbar (A) to junction box.

Mount the Crossbar (A) to the junction box by using provided Mounting Screws (B) as shown

in the picture.

4.

Using Wire Nuts (C) connect black wire from fixture to black wire from junction box. Connect white wire from fixture to white wire from junction box. Connect green wire of fixture to green or copper ground wire from the junction box. NOTE: Some junction boxes may not have a ground wire. In this case, attach green wire from the fixture to the ground screw located on

Crossbar (A), as shown in the picture.

5.

Tuck wires back into junction box.

6.

Screw Finial Nut (D) onto Crossbar, Slide Canopy (E) back up cord and against the ceiling, then use Compression Nut (F) to fix the Canopy (E), pls don't over tighten the Compression

7.

Nut (F).

Attach Shade (G) to the Lamp Cup (H). through decorative ring (I),and then screw on the socket

8.

ring (J) colckwise until tight.

Install bulb (not included).