UNIVERSAL

HARDWARE

The Professional’s Choice

UNIVERSAL MOUNTING PLATE

UH4061/UH4062 INSTALLATION INSTRUCTIONS

1

Remove door closer to be replaced. Determine door handing and installation type. Align holes in the mounting plate with the existing mounting holes in the door.

Notes:

• When installing mounting plate; make sure you can see the FRONT of the plate with properly marked handing and that the HINGE side of plate matches illustrations shown. Plate is marked with a sticker that designates the front and hinge side.

• The mounting plate may have to be flipped in some cases when used in a parallel arm installation so the hinge sticker is facing opposite side of illustration. Flip plate from left to right or right to left. DO NOT FLIP PLATE FROM TOP TO BOTTOM.

Regular Arm Installation

Left Hand Door - LH

Right Hand Reverse - RHR

Top Jamb Installation

Right Hand Door - RH

Left Hand Reverse - LHR

Left Hand Door - LH

Right Hand Reverse - RHR

Parallel Arm Installation

Right Hand Door - RH

Left Hand Reverse - LHR

Left Hand Door - LH

Right Hand Reverse - RHR

Right Hand Door - RH

Left Hand Reverse - LHR

UNIVERSAL

HARDWARE

The Professional’s Choice

UNIVERSAL MOUNTING PLATE

UH4061/UH4062 INSTALLATION INSTRUCTIONS

2

Attach mounting plate to the door or jamb using supplied fasteners following

"Preparation For Fasteners" chart (Page 2).

3

Install UH4061/UH4062 door closer on the mounting plate with

(1/4" x 20 - 5/8" screws) and install arm onto closer. Refer to "Main

Arm Installation" (Pages 3-5; dependent on installation type) for correct arm preload.

Notes:

• When installing forearm shoe or parallel arm bracket reuse existing holes if possible.

• If existing forearm shoe holes or existing parallel arm holes cannot be used, redrill new holes in door or frame; following "Door Closer

Installation Instructions"(Pages 3-5; dependent on installation type).

4

To adjust closer refer to "Door Closer Installation Instructions" provided

(Page 6).

Regular Arm Installation shown

©2015 Hampton Products International Corp.

50 Icon, Foothill Ranch, CA 92610-3000 USA www.universalhardware.com • 1-800-562-5625

95050000_UH4061-62_REVA

05/15 #95050000