advertisement
▼
Scroll to page 2
of 3
Specifications Extron XPA 1002, XPA 2001-70V, XPA 2001-100V Half-Rack Audio Power Amplifiers Audio Voltage gain XPA 1002��������������������������������������� 16x (24 dB) XPA 2001-70V������������������������������� 57x (35 dB) XPA 2001-100V����������������������������� 81x (38 dB) Stereo channel separation�������������� >75 dB @ 1 kHz CMRR�������������������������������������������� 75 dB @ 1 kHz (typical) Audio input Number/signal type������������������������ 1 stereo or 2 mono, balanced/unbalanced Connectors������������������������������ (1) 3.5 mm captive screw connector, 5 pole Impedance������������������������������� >10k ohms unbalanced/balanced, DC coupled Nominal level��������������������������������� +4 dBu (1.23 Vrms), balanced Maximum level������������������������������� +20 dBu (7.75 Vrms), balanced Input sensitivity XPA 1002�������������������������������� +4 dBu (1.23 Vrms) XPA 2001-70V, XPA 2001-100V +4 dBu (1.23 Vrms) if driven by one input -2 dBu (0.615 Vrms) if both inputs are summed Input signal detection threshold����� -40 dBu ±3 dB, balanced NOTE: 0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV ≈ 2 dBu Audio output Numbers/signal type XPA 1002�������������������������������� 1 stereo, 4- or 8-ohm direct XPA 2001-70V������������������������� 1 mono, 70 V line XPA 2001-100V����������������������� 1 mono, 100 V line Connectors XPA 1002�������������������������������� (1) 5 mm screw lock captive screw connector, 4 pole XPA 2001-70V, XPA 2001-100V (1) 5 mm screw lock captive screw connector, 2 pole NOTE: These connectors accept wires of 22 AWG to 12 AWG. Extron XPA 1002, XPA 2001-70V, XPA 2001-100V Half-Rack Audio Power Amplifiers • Specifications 1 Load impedance XPA 1002�������������������������������� 4 ohms minimum XPA 2001-70V������������������������� 25 ohms minimum XPA 2001-100V����������������������� 50 ohms minimum Amplifier type�������������������������������� Class D Output power XPA 1002�������������������������������� 60 watts rms per channel, 8 ohms, 1 kHz, <0.05% THD 100 watts rms per channel, 4 ohms, 1 kHz, <0.05% THD XPA 2001-70V������������������������� 200 watts rms, 70 V, 1 kHz, <0.1% THD XPA 2001-100V����������������������� 200 watts rms, 100 V, 1 kHz, <0.1% THD Frequency response������������������������ 20 Hz to 20 kHz, ±1 dB THD + Noise XPA 1002�������������������������������� 0.05% @ 20 Hz - 20 kHz, 8 ohms, at 3 dB below clipping XPA 2001-70V, XPA 2001-100V <0.1% @ 1 kHz at 3 dB below clipping S/N XPA 1002�������������������������������� 105 dB, 20 Hz - 20 kHz, unweighted XPA 2001-70V, XPA 2001-100V 100 dB, 20 Hz - 20 kHz, unweighted Damping factor XPA 1002�������������������������������� >100 @ 8 ohms XPA 2001-70V������������������������� >100 @ 25 ohms XPA 2001-100V����������������������� >100 @ 50 ohms High pass filter XPA 2001-70V, XPA 2001-100V 80 Hz, 12 dB per octave rolloff (switch selectable) Control/remote — amplifier Control port����������������������������������� (1) 3.5 mm captive screw connector, 5 pole Pin configurations DC volume control (analog)����� Pin 1 = +10 VDC, 50 mA (max.), pin 2 = volume/mute (variable voltage), pin 3 = GND Volume control voltage range�� 0 V (mute to 10 V (maximum volume) Standby power control (contact closure) Pin 4 = GND, pin 5 = standby General Power supply���������������������������������� Internal Input: 100-240 VAC, 50-60 Hz, 0.5 A Power consumption Typical (1/8 power) XPA 1002��������������������������� 4 ohms (x2): 43 watts 8 ohms (x2): 30 watts XPA 2001-70V������������������� 70 V (x1): 45 watts XPA 2001-100V����������������� 100 V (x1): 45 watts Quiescent XPA 1002��������������������������� 10 watts XPA 2001-70V, XPA 2001-100V 12 watts Standby����������������������������������� <1 watt (triggered by contact closure or after 25 minutes [±5 minutes] with no signal) Temperature/humidity�������������������� Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing Cooling������������������������������������������ Convection, no vents, with internal heat sinks Thermal dissipation Standby����������������������������������� <1 watt (3 BTU/hr) Extron XPA 1002, XPA 2001-70V, XPA 2001-100V Half-Rack Audio Power Amplifiers • Specifications 2 Idle XPA 1002��������������������������� 10 watts (34 BTU/hr) XPA 2001-70V, XPA 2001-100V 12 watts (41 BTU/hr) 1/8 power (pink noise) XPA 1002��������������������������� 4 ohms (x2): 18 watts (62 BTU/hr) 8 ohms (x2): 15 watts (53 BTU/hr) XPA 2001-70V������������������� 70 V (x1): 21 watts (71 BTU/hr) XPA 2001-100V����������������� 100 V (x1): 20 watts (69 BTU/hr) Protection�������������������������������������� Clip limiting, thermal, short circuit, DC output Indication��������������������������������������� Limiter/Protector LED indicates the onset of clip limiting, thermal cycling, short circuit Mounting Rack mount����������������������� Yes, with optional 1U rack shelf Enclosure type�������������������������������� Metal Enclosure dimensions��������������������� 1.7" H x 8.7" W x 9.5" D (1U high, half rack wide) (4.3 cm H x 22.1 cm W x 24.1 cm D) Product weight������������������������������� 2.5 lbs (1.1 kg) Shipping weight����������������������������� 5 lbs (3 kg) Vibration���������������������������������������� ISTA 1A in carton (International Safe Transit Association) Regulatory compliance Safety�������������������������������������� CCC, CE, c-UL, GS, KC Mark, PSE, S Mark, UL, BSMI UL rated for use in plenum airspaces: meets UL 2043 for heat and smoke release; meets UL 60065, IEC 60065, and BSEN 60065 for AV equipment. EMI/EMC��������������������������������� CE, CISPR 22 Class B, C-tick, FCC Class B, ICES, VCCI Class B Environmental�������������������������� Complies with the appropriate requirements of ENERGY STAR® (ENERGY STAR qualified amplifier), EU code of conduct, RoHS, WEEE MTBF��������������������������������������������� 250,000 hours Warranty���������������������������������������� 3 years parts and labor NOTE: All nominal levels are at ±10%. NOTE: Specifications are subject to change without notice. Extron XPA 1002, XPA 2001-70V, XPA 2001-100V Half-Rack Audio Power Amplifiers • Specifications 3
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement