LG WP-582N Owner’s Manual

INSTALLATION
Installation
Set
on
INSTALLATION & HOW TO WASH
Maintain
area
more
than 10
between
cm
A
Incorect installation may course
severe noise and break down.
carpet
must not obstruct the
ventilation
the earth wire and the power
Connecting
the side of drain hose and the wall.
flat and firm floor
Install the earth wire to prevent short-circuit due to
openings.
leaking
It is attached at the back of the washer. Connect it to the metal water
is made of
pipe
pipe, lightning
Connecting
outlet of the
clamp toward the body
of the washing machine as shown
in the figure.
?
plunger valve located
washing
at the back side of the
Push the
machine.
Gas
Unplug
for Dual
method
earthing
connecting
the earth
wire to the earth copper
plate, bury it at least 75cm
Voltage)
the power cord from the electric outle, Use screwdriver to
bag covering the lead wire couplers.
back
remove
change
the
voltage setting
from 220V to
marked "220V" and connect the
Connect to the
When
earthing-only outlet.
area
cover
5.
from
110(127)V, disconnect the coupler
"110(127)V", to change the voltage
the coupler marked "110(127)V" and
Earth
machine tub when not in
Short-circuit breaker
Earth
75cm
Earth copper
plate
cover.
Washing
1
clothing to be washed.
2. Remove all objects from the pockets of the clothing.Objects left in the pockets may
damage clothing or the washing machine (could cause the drain hose to clog).
3. After separating oiled or dyed clothing, wash.
4. For your convenience hang up the wash cover on the right or left side of the washing
on
a
short-circuit breaker
connect it to the outlet.
wire
washing
1. Check the washing instruction labels
where
wire
For Non
Before
installing it in an
earthing is
possible, purchase
not
deep under the wet
ground.
marked
110(127)V to 220V, disconnect
connect the coupler marked "220V".
Cover the couplers with the bag and reattach the back
Be sure to indicate the new voltage setting on the
"Present Voltage" label for future reference.
setting
4.
coupler
Earth
wire
WARNING-THIS APPLIANCE MUST BE EARTHED.
2. Remove the
3. To
pipe
telephone
of the washer matches the out
voltage setting
let voltage.
After
1.
arrester.
Insert the power plug into the outlet.
Before connecting the power plug, check if the
Other
Voltage Change (Only
If the water
connecter, etc.
the drain hose
Connect the drain hose to the
?
pipe.
it does not have the earth effect.
plastic,
Never connect the earth wire to the
gas
plugh
current and electric shock.
the
Pump
Caution
:
Don't rotate knob
over on
Fill water till water level
2 mark"H".That is because 3
clothes
absorb
can
adequate
)
Put the
appropriate
detergent and
laundry into the wash
amount of
the
tub. And add water to the
desired water level which
amount of
water and water will not
you want.
short.
For
(
curve.
Model
Set the drain selector to
"WASH RINSE" position.
use.
spot
Model
Pump
Off
H
???
Drain Selector
r
4
5
REFERENCE & AFTER FINISHING
HOW TO WASH & HOW TO RINSE
TABLE 1. WEIGHT GUIDE FOR CLOTHES
4
Set the desired wash
time.
When
washing
is
5 finished, locate the
Non-Pump Model
Type
Pump Model
drain selector to
"DRAIN"
position
of
Handkerchief
Cotton
Bath towel
Cotton
Shirt
Mixed fabric
Socks (1 pair)
Pajama (shirt and pants)
Mixed fabric
drain the water out.
Drain Selector
Interim
Interim
spin
laundry
and
spin
Drain Selector
rinse
rinse
prior to regular rinsing helps removing sudsy water from
improve rinsing efficiency. Also is helpful to water saving.
Cotton
Workclothes
Mixed fabric
Blouse
Mixed fabric
the
After washing.
Move the
laundry into
spin dryer basket.
Place the safety cover
horizontally on the
laundry.
2
Set the desired spin
flow
appropriately.
the
3
After interim
rinse,
TABLE 2. GUIDE FOR WASHING
spin
H
the
move
laundry
into the
wash tub for
1.
2
dryer
Timer
Safety cover
spinning
into the
basket and
If there is water in the wash tub, set the drain selector
in order to drain it out.
.
(For Pump Model Only : and
For Pump Model Only
Ensure without fail the drain selector is turned to
6.
If
washing and spinning
spinning operation shall
must be
2. Put the
Spin dryer
not
be done at the
6
the
same
time to cope with EMC
using
and
requirement.
Requesting Service
operate,
basket does
operate.
Checking point
firmly plugged in?
Is the timer turned to a suitable point except "OFF" ?
Is there any clothing dropped between the basket and
Is the spin dryer cover closed?
Is the power cord
Is the
spin dryer basket is off-balance and vibrates excessively, stop
spinning, rearrange the clothes evenly, and then resume spinning.
"OFF" Position after
operated together, starting washing
TROUBLESHOOTING GUIDE
Motor does not
If the
to "OFF")
5.
Problem
laundry down lightly.
safety cover horizontally
over the laundry.
Close the spin dryer cover.
put it back
4.
Before
basket.
then
Disconnect the power cord from the electrical outlet.
Clean the washing machine.
spin
3. Place the
4.
laundry from the spin dryer
spin dryer cover.
detergent
34g
to "DRAIN"
HOW TO SPIN
laundry evenly
Amount of
34L
Remove the
3.
Spin
1. Put the
Amount of water
(Maximum Level)
close the
rinsing.
4
Note for
Weight per piece
150g(53oz)
50g(1.8oz)
300g(10.6oz)
200g(7.1oz)
50g(1.8oz)
500g(17.6oz)
600g(21.2oz)
800g(28.2oz)
200g(7.1oz)
Cotton
Winter undershirt
Water level
1
of fabric
Type
Cotton
and
Wash Timer
clothing
Under shirt
Off
laundry gathered
draining
For Non-Pump Model
Is there lint stuck in the
For
Is the drain pump
No
Pump Model
to
one
spin dryer
basket?
plunger valve?
Is the end of the drain hose
7
side of the
tub?
operated?
guide
located at
an
exceed
height?