Instructions for use
ENGLISH
Instructions for use
3
Page 4
IMPORTANT SAFETY INSTRUCTIONS
• WARNING: to avoid a hazard due
to instability, positioning or fixing
of the appliance must be done in
accordance with the manufacturer
instructions.
• WARNING: keep the appliance
ventilation openings clear of
obstruction.
• WARNING: do not damage the
appliance refrigerant circuit pipes.
• WARNING: Do not use mechanical,
electric or chemical means other
than those recommended by the
Manufacturer to speed up the
defrost process.
• WARNING: Do not use or place
electrical devices inside the
appliance compartments if they are
not of the type expressly authorised
by the Manufacturer.
• WARNING: ice-makers and/
or water dispensers not directly
connected to the water supply
must be filled with potable water
only.
• C-Pentane is used as blowing
agent in the insulation foam
and it is a flammable gas. Pay
special attention during disposal
operations.
• This appliance is intended to be
used in household and similar
applications such as
- staff kitchen areas in shops, offices
and other working environments;
- farm houses and by clients
in hotels, motels and other
residential type environments;
- bed and breakfast type
environments;
- catering and similar non-retail
applications
• Do not store explosive substances
such as aerosol cans with a
flammable propellant in this
appliance.
• This appliance can be used by
children aged from 8 years and
above and persons with reduced
physical, sensory or mental
capabilities or lack of experience
and knowledge if they have been
given supervision or instruction
concerning use of the appliance
in a safe way and understand the
hazards involved.
• Cleaning and user maintenance
shall not be made by children
without supervision.
• To avoid the risk of children
becoming trapped and suffocating,
do not allow them to play or hide
inside the appliance.
• It must be possible to disconnect
Information: This appliance does
not contain CFCs. The refrigerant
circuit contains R600a (HC).
• Appliances with Isobutane (R600a):
isobutane is a natural gas without
environmental impact, but is
flammable. Therefore, make sure
the refrigerant circuit pipes are not
damaged. Keep special attention in
case of damaged pipes emptying
the refrigerant circuit.
4
the appliance from the power
supply by unplugging it if plug
is accessible, or by means of
an accessible multi-pole switch
installed upstream of the socket
in conformity with national safety
standards.
• Plug the appliance into a
grounding socket: the appliance
must be correctly connected to an
approved earthing system.
• Do not use single/multi adapters or
extension cords.
• During installation, make sure the
appliance does not damage the
power cable.
• Do not pull the appliance power
cable.
• The appliance must be handled and
installed by two or more persons.
• In order to avoid an hazard,
installation and maintenance,
including Power cable replacement,
must be carried out by a qualified
technician, in compliance with the
manufacturer’s instructions and the
local safety regulations in force. Do
not repair or replace any part of the
appliance unless specifically stated
in the user manual.
SAFEGUARDING THE ENVIRONMENT
1. Packing
The packing material is 100% recyclable and bears the
recycling symbol . For disposal, comply with the
local regulations. Keep the packing materials (plastic
bags, polystyrene parts, etc.) out of the reach of
children, as they are a potential source of danger.
Scrap the appliance in compliance with local
regulations on waste disposal, taking it to a special
collection centre; do not leave the appliance
unattended even for a few days, since it is a potential
source of danger for children.
For further information on the treatment, recovery and
recycling of this product, contact your competent local
office, the household waste collection service or the
shop where you purchased the appliance.
2. Scrapping/Disposal
The appliance is manufactured using recyclable
material.
This appliance is marked in compliance with
European Directive 2012/19/EU on Waste Electrical
and Electronic Equipment (WEEE). By ensuring the
correct disposal of this appliance, you can help
prevent potentially negative consequences for the
environment and the health of persons.
Declaration of conformity
• This appliance has been designed for preserving
food and is manufactured in compliance with
Regulation (CE) No. 1935/2004.
• This appliance has been designed, manufactured
and marketed in compliance with:
- safety objectives of the “Low Voltage” Directive
2006/95/CE (which replaces 73/23/CEE and
subsequent amendments);
- the protection requirements of Directive “EMC”
2004/108/EC.
on the appliance, or on the
The symbol
accompanying documents, indicates that this
appliance should not be treated as domestic waste but
must be taken to a special collection centre for the
recycling of electrical and electronic equipment.
When scrapping the appliance, make it unusable by
cutting off the power cable and removing the doors
and shelves so that children cannot easily climb inside
and become trapped.
5
BEFORE USING THE APPLIANCE
To ensure best use of your appliance, carefully
read the operating instructions which contain a
description of the product and useful advice.
Keep these instructions for future reference.
1.After unpacking the appliance, make sure it is not
damaged and that the door closes properly. Any
damage must be reported to the dealer within
24 hours of delivery of the appliance.
2.Wait at least two hours before switching the
appliance on, to ensure that the refrigerant circuit is
fully efficient.
3.Clean the inside of the appliance before using it.
PRECAUTIONS AND GENERAL RECOMMENDATIONS
INSTALLATION
• Be careful not to damage the floors (e.g. parquet)
when moving the appliance.
• Make sure the appliance is not near a heat source.
• Install and level the appliance on a floor strong
enough to take its weight and in a place suitable for
its size and use.
• The appliance is arranged for operation in places
where the temperature comes within the following
ranges, according to the climatic class given on the
rating plate. The appliance may not work properly if
it is left for a long time at a temperature outside the
specified range.
• Do not eat ice cubes or ice lollies immediately after
taking them out of the freezer since they may cause
cold burns.
• For products designed to use an air filter inside an
accessible fan cover, the filter shall be always in
position when the refrigerator is in function.
• Before carrying out any maintenance or cleaning
operation, unplug the appliance or disconnect it
from the power supply.
• Use the refrigerator compartment only for storing
fresh food and the freezer compartment only for
storing frozen food, freezing fresh food and making
ice cubes.
• Do not store glass containers with liquids in the
freezer compartment since they may break.
• Avoid storing unwrapped food in direct contact
with internal surfaces of the refrigerator or freezer
compartments.
• “The bulb used inside the appliance is specifically
designed for domestic appliances and is not suitable
for general room lighting within the home (EC
Regulation 244/2009)”.
Climatic Class
Amb. T. (°C)
SN
From 10 to 32
N
From 16 to 32
ST
From 16 to 38
T
From 16 to 43
• Make sure the voltage specified on the rating plate
corresponds to that of your home.
The Manufacturer declines any liability for injury
to persons or animals or damage to property if the
above advice and precautions are not respected.
SAFE USE
• Do not store or use petrol, flammable liquids or gas
in the vicinity of this or other electrical appliances.
The fumes can cause fires or explosions.
• Do not swallow the contents (non-toxic) of the ice
packs (in some models).
6
ELECTRICAL CONNECTION FOR GREAT BRITAIN AND IRELAND ONLY
Warning - this appliance must be earthed
Fuse replacement
If the mains lead of this appliance is fitted with a BS 1363A 13amp fused
plug, to change a fuse in this type of plug use an A.S.T.A. approved fuse
to BS 1362 type and proceed as follows:
1. Remove the fuse cover (A) and fuse (B).
2. Fit replacement 13A fuse into fuse cover.
3. Refit both into plug.
Important:
The fuse cover must be refitted when changing a fuse and if the fuse cover is lost the plug must not be used until
a correct replacement is fitted.
Correct replacement are identified by the colour insert or the colour embossed in words on the base of the plug.
Replacement fuse covers are available from your local electrical store.
For the Republic of Ireland only
The information given in respect of Great Britain will frequently apply, but a third type of plug and socket is also
used, the 2-pin, side earth type.
Socket outlet / plug (valid for both countries)
If the fitted plug is not suitable for your socket outlet, please contact After-sales Service for further instruction.
Please do not attempt to change plug yourself. This procedure needs to be carried out by a qualified technician in
compliance with the manufactures instructions and current standard safety regulations.
ENERGY-SAVING TIPS
• Install the appliance in a dry, well ventilated room
far away from any heat source (e.g. radiator, cooker,
etc.) and in a place not exposed directly to the sun. If
required, use an insulating plate.
• To guarantee adequate ventilation follow
installation instructions.
• Insufficient ventilation on back of the product
increases energy consumption and decreases
cooling efficiency.
• The internal temperatures of the appliance may be
affected by the ambient temperature, frequency of
door opening, as well as location of the appliance.
Temperature setting should take into consideration
these factors.
• Allow warm food and drinks to cool down before
placing in the appliance.
• Do not obstruct the fan (if available) with food items.
• After placing the food check if the door of
compartments closes properly, especially the freezer
door.
• Reduce to a minimum door opening.
• When thawing frozen food, place them in the
refrigerator. The low temperature of the frozen
products cools the food in the refrigerator.
• Appliances could have special compartments (Fresh
Food Compartment, Zero Degree Box,...). In case
not differently specified in the specific booklet
of product, they can be removed, maintaining
equivalent performances.
• Positioning of the shelves in the refrigerator has
no impact on the efficient usage of energy. Food
should be placed on the shelves in such way to
ensure proper air circulation (food should not touch
each other and distance between food and rear wall
should be kept).
• You can increase storage capacity of frozen food by
removing baskets and, if present, Stop Frost shelve,
maintaining an equivalent energy consumption.
• Damaged gasket must be replaced as soon as
possible.
• High energy class products are fitted with highefficiency motors that remain operational for longer,
but have a low power consumption. Do not worry if
the engine continues to run for longer periods.
7
19513873600
GB
03/17
">
