Wasp Bar Code Scanner WPA1200 User manual

Caution: When the main battery is removed, the backup
battery retains RAM data in memory for 2 hours, please
charge the battery for the period to avoid the data loss in RAM
memory.
5. Using the SD/MMC Memory Card
a. Remove the two
screws from the SD
compartment cover
and remove the cover.
Power Button
#1, Left Soft
b. Insert the SD card with
the notched corner as
shown by the icon on
the case.
c.
Push the card into the slot until you hear an
audible system sound; this will signal that the
card is already properly seated within the slot
Function Keys
Tab, Open Windows
#2, abc, Up
#7, pqrs, Brightness
#3, def, Right Soft
Enter key, OK
#8, tuv, Down
Backspace, Escape
Alpha
WPA1200
Quick Start
Guide
#9, wxzy, Brightness
#4, ghi, Left
Asterisk, Illuminate
#5, jkl
Number 0, Spaces
#6, mno, Right
Period, Pounds
6. Keypads and Function Buttons
When the Function button is pressed, an icon
appears in the operating system.
Function Activated Icon
© 2007 Wasp Technologies
Front Left View
1.
2.
3.
4.
5.
6.
7.
8.
Status Indicator
Left scan trigger button
Power button
Microphone
Universal connector
Keypad
LCD touch screen
Speakers
Back View
12.
13.
14.
15.
16.
17.
18.
19.
20.
Handstrap
Speaker
Strap holder
Memory card slot
Barcode scanner window
Earphone Jack
Stylus
Right scanner trigger button
Infrared (IR) Port
1. Turning the WPA1200 On for the
First Time
After you have initially charged your
device for about 12 hours, the device is
ready to be used. You can now start up
your device where you’ll calibrate the
display, learn some basic stylus usage,
and set up the system time zone, date and
time.
Turn on your device by pressing the power
button on the front panel. (Number 3 in the
graphic above.)
3. Installing the Battery Pack
Open the battery compartment by pushing
the latch in the direction of the arrow and
lifting up.
9. Battery compartment
10. Battery compartment release Latch
11. Reset button
Slide the battery pack into the battery bay
while simultaneously pulling the plastic tab
and securing clip until the battery clicks
into place.
Tab
Clip
Replace the battery compartment cover.
4. Charging the Battery
2. Powering On
Compartment
Contacts
Position the battery pack, making sure the
battery contacts are aligned with the
contacts in the compartment and the
battery is placed on top of the plastic tab,
as shown in the following illustration.
Plastic Battery
Tab
Battery Securing
Clip
a. Press and hold the connector
button on the USB charging
cable and connect it to the
WPA1200.
b. Plug the AC adapter cable into
the power jack on the USB
charging cable (2).
c.
Connect the AC adapter into
an electrical outlet (3).