advertisement
▼
Scroll to page 2
OWNER’S MANUAL April 2005 Running Gear No. 50HD (300 026) 1. 224 609A OM-6620 Parts List WARNING ELECTRIC SHOCK can kill. • • • FALLING EQUIPMENT can cause injury and damage. Do not touch live electrical parts. Turn Off power source and input disconnect device. Disconnect input plug or power conductors from deenergized supply BEFORE moving power source. Tools Needed: • • • Properly install and secure power source into holes provided on cart. Always secure or remove any tools stored on cart before moving unit. Cart is only designed to handle weight of power source, cables, torch, and a few simple tools − do not overload cart with any additional weight. 3/8, 7/16 in 3/8, 7/16 in Item No. 2 3 1 Description (Qty) 1 224 124 Pan/Shelf Assembly (1) 2 3 224 120 Bracket, Cable Hanger (4) 602 154 Screw, 250-20x.50 (4) 4 5 121 614 Retaining Ring (2) 602 250 Washer, .812 ID flat (2) 6 7 163 463 Wheel, 10 in (2) 224 114 Axle (1) 8 9 123 557 Caster, 5 in (2) 602 247 Washer, .531 ID flat (2) 10 602 216 Washer, .502 ID lock (2) 11 124 115 Nut, 438-14 Hex (2) 12 152 461 Nut, 250-20 Hex (4) 14 13 224 115 Handle (1) 14 601 941 Screw, 250-20x1.75 Hex (4) 12 13 224 388 Mounting Bracket (4) see Section 3. Be sure to provide Model when ordering replacement parts. Go to Section 2 for procedures to install cable hangers and handle. 11 10 9 7 8 6 5 4 Ref. 804 166-A © 2005 MILLER Electric Mfg. Co. 2. Assembly Instructions 1 2 1 224 120 Cable Hanger (2) 224 115 Handle Install left and right cable hanger by inserting a socket wrench through access hole and securing hanger using supplied hardware. Insert handle into holes located below top tray, and secure using supplied hardware. 2 Ref. 804 166-A 3. Installing Power Source 1 Mounting Bracket (224 388) 2 Screw, 250-20 x 1.00 (108 941) 3 Nut, 250-20 (152 461) Place power source on top or bottom tray. Select a set of holes that align with the lower sheet metal screws on unit. 1 2 Remove lower sheet metal screws from unit. Install mounting brackets and secure with supplied hardware. Place unit between brackets and reinstall sheet metal screws through brackets and back into unit. 3 804 167-A OM-6620 Page 2
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project