advertisement
◉
Touch to zoom
OWNER’S MANUAL November 1994 FORM: OM-678B Use above FORM number when ordering extra manuals. Running Gear/Economy Cart (134 505) WARNING ELECTRIC SHOCK can kill. • • • FALLING EQUIPMENT can cause injury and damage. Do not touch live electrical parts. Turn Off welding power source and input disconnect device. Disconnect input power conductors from deenergized supply BEFORE moving welding power source. • • • Use proper equipment to lift unit. Use lifting forks long enough to extend out opposite side of base. Do not put any body part under unit while lifting. miscwarn1.1* 2/94 To install XMT models, remove rubber mounting pads from bottom of unit and partially install two screws (4) into the rear mounting holes. Slide screws into the matching slotted holes on the running gear shelf (5). Install remaining two screws from the bottom of the shelf and tighten all four. Item Part No. No. Description (Qty) 1 142 312 Handle (1) 2 3 090 099 Insulator (1) 044 800 Washer, 3/4 cone (1) 4 080 389 Screw, 5/16-18 x 1 (XMT Models) (4) 5 6 142 315 Shelf (1) 601 879 Nut, 1/2-13 (2) 7 8 602 216 Washer, 1/2 lock (2) 090 693 Wheel, 8 in (2) 9 020 824 Axle (1) 10 121 614 · Retaining Ring (2) 11 137 077 Caster (2) 1 2 3 12 602 207 Washer, 1/4 lock (4) 13 601 865 Nut, 1/4-20 (4) 4 4 14 108 942 Screw, 1/4-20 x 1-1/4 (4) Maxtron 300 Base Mounting Hardware 089 799 Screw, 1/4-20 x 1/2 (4) 5 602 207 Washer, 1/4 lock (4) 601 865 Nut, 1/4-20 (4) Be sure to provide Model when ordering replacement parts. 6 13 7 12 14 11 Remove paint from axle grooves (9) before installing retaining rings (10). 8 Tools Needed: 9 10 3/8, 7/16, 1/2 ST-137 344-B / ST-800 245 Figure 1. Installing Running Gear/Economy Cart
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project