RY14122 QUICK REFERENCE GUIDE
WARNING:
This Quick Reference Guide is not a substitute for reading the operator’s manual. To reduce the risk of injury or death, user must read and understand operator’s manual before using this product. All page references refer to the operator’s manual.
FIRST TIME ASSEMBLY STARTING THE UNIT
1 Install the wheels
(see page 9).
5 Connect the high pressure hose to the trigger handle
(see page 9).
1 Connect the pressure washer to the power supply. Press the reset button on the plug to make sure the unit is ready for operation
(see page 11).
There may be residual water in the pump due to performance testing.
1 Pour pressure washer detergent in soap tank
(see page 13).
USING DETERGENT
2 Install blue or black soap nozzle
(see page 11).
3 Squeeze trigger and wait approx. 5 seconds for detergent
(see page 13).
DETERGENT 5 S 2 Install the handle
(see page 9).
3 Install the trigger handle storage bracket
(see page 9).
4 Connect the spray wand to the trigger handle
(see page 9).
6 Connect the high pressure hose to the pump
(see page 9).
7 Connect your garden hose to the pressure washer
(see page 9).
Completely uncoil garden hose or remove completely from reel to prevent kinks.
Turn water faucet on fully. Make sure there are no leaks. With no nozzle installed, squeeze the trigger to relieve air pressure. Hold the trigger until a steady stream of water appears.
If using an extension cord, arrange a drip loop to avoid the possibility of the tool plug getting wet
(see pages 2 and 7).
USE ONLY THIS SIZE EXTENSION CORD WHEN USING THIS PRODUCT: Cord Length
25 ft.
50 ft.
100 ft.
NOTE: A.W.G. = American Wire Gauge
Wire Size (A.W.G.)
14 12 Not Allowed
Use of soap nozzle will activate soap injector at a 20:1 dilution ratio.
WARNING! Never use bleach or solvent-based detergent. • Will damage your pump • Will void your warranty • Will damage plants/shrubs
NOZZLE SELECTION GUIDE
Use the chart below to determine the correct nozzle for your job.
HIGH PRESSURE (NO SOAP WHEN USING THESE NOZZLES) LOW PRESSURE (FOR SOAP OR GENTLE RINSE) 2 Press switch ON to start the motor
(see page 11).
SWITCH ON 3 When finished, press switch OFF to stop the motor
(see page 11).
SWITCH OFF Turbo Nozzle 15º Blue or Black Soap Nozzle Concrete, Brick, Masonry Siding, Gutters, House Fencing, Deck, Patio Lawn Equipment, Boat, RV
Recommended Nozzle
Use With Caution for Certain Applications
BEFORE STORING THE UNIT
1 Always add Pump Protector to the unit after each use and before storing. This will significantly im prove pump life. 1-800-860-4050.
(See page 13)
Pump Protector is available from your local retailer. For further assistance, call customer service at To add, follow the instructions provided by the pump protector manufacturer.
PUMP PROTECTOR Make the most of your purchase! Go to www.ryobitools.com and register your new tool online. For questions about operating or maintaining your product, please call 1-800-860-4050.
990000378 7-31-18 (REV:05)
