These changes are the result of the following product enhancement: New case mounting design. This addendum applies to Part 2 Hardware in your iServer Operator’s Manual.
2.1 Wall Mounting
Position unit where required. Mark and drill the two #4 screw holes. After bracket is mounted on the wall, align back of unit over the three bracket clips, once engaged, slide downward, the unit will snap in place. 0.52 [13.3] 1.50 [38.1] 1.26 [32.1] DRILL 0.125 [3.17] USE TWO, #4 FLAT HEAD SCREWS TO MOUNT BRACKET BRACKET CLIPS (3)