MXW

Quick Setup MXW Wireless System

௔ ௕ ௘ ௖ ௗ

① Wireless Microphones ② System processor and wireless transceiver ③ Microphone linking and charging station ④ Analog output device with gigabit network switch ⑤ Shielded Cat5e cables (not included)

Connect the System

MXW ANI

Cat5e shielded cables 5 1 2 6 3 4 7 8 ©2017 Shure Incorporated 5 1 6 2 3 7 4 8

MXW APT Class 0 PoE

1/10

MXW ANI MXW ANI

5 1 6 2 3 4 7 8 1 2 5 6 3 4 7 8 MXW Quick Setup 1 2 3 4 5 6 7

Power On the Devices

8

MXW APT Class 0 PoE

5 1 6 2 3 7 4 8

Class 0 PoE

The APT requires power over Ethernet (PoE) Shure Incorporated

Charge the Microphones

MXW APT Note

: the MXWNCS2 does not operate with gooseneck microphones.

Download the Shure Discovery Application

To discover and access Shure devices on the network, download the Shure Web Device Discovery application from the Shure website.

2/10 2017/10/06

MXW Quick Setup

View Devices on the Network

The Discovery app displays Shure devices networked to the computer.

Shure Incorporated 2017/10/06 3/10

Shure Incorporated MXW Quick Setup

Open the APT Web Interface

4/10

admin

The default password is admin

2017/10/06

MXW Quick Setup

Select Devices for the Group

Shure Incorporated

MXW APT +

5 1

MXW NCS

2 3 4 6 7 8

+ MXW

The group channel count is determined by the access point (APT) model: 2, 4 or 8 channels.

ANI

INPUT A sig/clip mute B line aux OUTPUT 1 sig/clip mute 2 3 4 5 push to solo | hold to mute 6 7 8 line aux mic -9 0 -12 -18 -24 adjust 0 -9 -18 -24 -36 -48 -60 power ethernet network audio lockout HEADPHONE MICROFLEX WIRELESS Audio Network Interface 2017/10/06 5/10

MXW Quick Setup 2 link 1 5 9 10 11 12 1 2 8 7 6 5 2 4 3 link 5 6 6 3 7

using the hardware

4 7

using the network

8 3 Shure Incorporated 6/10 2017/10/06

MXW Quick Setup

Remove the Microphones

Microphone LEDs stop flashing when it is ready to use.

Shure Incorporated 9 8 10 11 12 1 7 6

5

5 2 4 3 2017/10/06 7/10

MXW Quick Setup

Test the Audio

Shure Incorporated INPUT A sig/clip mute B line aux OUTPUT 1 sig/clip mute 2 3 4 5 push to solo | hold to mute 6 7 8 line aux mic -9 -12 -18 -24 0 adjust -9 -18 -24 -36 -48 -60 0 power ethernet network audio lockout HEADPHONE MICROFLEX WIRELESS Audio Network Interface INPUT A sig/clip mute B line aux OUTPUT 1 sig/clip mute 2 3 4 5 6 7 8 push to solo | hold to mute line aux mic 0 -9 -12 -18 -24 adjust 0 -9 -18 -24 -36 -48 -60

select the desired channel use headphones

Safety Information

SAFETY PRECAUTIONS

The possible results of incorrect use are marked by one of the two sym bols—"WARNING" and "CAUTION"—depending on the imminence of the danger and the severity of the damage.

WARNING: Ignoring these warnings may cause severe injury or death as a result of incorrect operation.

CAUTION: Ignoring these cautions may cause moderate injury or property damage as a result of incorrect operation.

WARNING LISTENING TO AUDIO AT EXCESSIVE VOLUMES CAN CAUSE PERMA NENT HEARING DAMAGE. USE AS LOW A VOLUME AS POSSIBLE.

Over exposure to excessive sound levels can damage your ears resulting in permanent noise-induced hearing loss (NIHL). Please use the following guidelines established by the Occupational Safety Health Administration (OSHA) on maximum time exposure to sound pressure levels before hearing damage occurs.

8/10

90 dB SPL

at 8 hours

110 dB SPL

at ½ hour

95 dB SPL

at 4 hours

115 dB SPL

at 15 minutes

100 dB SPL

at 2 hours

105 dB SPL

at 1 hour

120 dB SPL

Avoid or damage may occur • • • • • • •

WARNING

Battery packs may explode or release toxic materials. Risk of fire or burns. Do not open, crush, modify, disassemble, heat above 140°F (60°C), or incinerate.

Follow instructions from manufacturer Only use Shure charger to recharge Shure rechargeable batteries WARNING: Danger of explosion if battery incorrectly replaced. Replace only with same or equivalent type.

Never put batteries in mouth. If swallowed, contact your physician or local poison control center Do not short circuit; may cause burns or catch fire Do not charge or use battery packs other than Shure rechargeable bat teries 2017/10/06

MXW Quick Setup Shure Incorporated • • Dispose of battery packs properly. Check with local vendor for proper disposal of used battery packs.

Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like

WARNING:

Danger of explosion if incorrect battery replaced. Operate only with AA batteries.

Note:

Use only with the included power supply or a Shure-approved equiva lent.

1. 經審驗合格之射頻電信終端設備，非經許可，公司、商號或使用者均不 得擅自變更頻率、加大功率或變更原設計之特性及功能。 2. 射頻電信終端設備之使用不得影響飛航安全及干擾合法通信；經發現有 干擾現象時，應立即停用，並改善至無干擾時方得繼續使用。所謂合法 通信，係指依電信法規定作業之無線電信。 3. 輸入、製造射頻電信終端設備之公司、商號或其使用者違反本辦法規定， 擅自使用或變更無線電頻率、電功率者，除依電信法規定處罰外，國家 通訊傳播委員會並得撤銷其審驗合格證明。 4. 減少電磁波影響，請妥適使用

MXW1

These transmitters have been tested and found to comply with international radiation exposure limits set forth for an uncontrolled environment. This equipment is in direct contact with the body of the user under normal operating conditions. These transmitters must not be co-located or operating in con junction with any other antenna or transmitter.

MXW2, MXW6, MXW8, MXWAPT2, MXWAPT4, MXWAPT8

These mobile transmitters are intended for use at distances greater than 20 centimeters from the human body. These mobile transmitters are exempt from the testing requirements of international radiation exposure standards due to their proximity to the body of the user in their intended use case and their low power output. These mobile transmitters shall be placed or installed at least 20 cm from any person and must not be co-located or operating in conjunction with any other antenna or transmitter.

Important Product Information

The equipment is intended to be used in professional audio applications.

EMC conformance testing is based on the use of supplied and recommended cable types. The use of other cable types may degrade EMC performance.

Changes or modifications not expressly approved by Shure Incorporated could void your authority to operate this equipment.

Please follow your regional recycling scheme for batteries, packaging, and electronic waste.

Note:

This device is not intended to be connected directly to a public internet network.

• • • •

Information to the user

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna.

Increase the separation between the equipment and the receiver.

Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Certifications

This device complies with FCC Part 15.

This device complies with Industry Canada licence-exempt RSS standard(s).

Operation of this device is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any inter ference, including interference that may cause undesired operation of the device.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.

Japanese Radio Law and Japanese Telecommunications Business Law Compliance. This device is granted pursuant to the Japanese Radio Law (電 波法) and the Japanese Telecommunications Business Law (電気通信事業 法). This device should not be modified (otherwise the granted designation number will become invalid).

Conforms to electrical safety requirements based on IEC 60065.

• • Meets essential requirements of the following European Directives: WEEE Directive 2002/96/EC, as amended by 2008/34/EC RoHS Directive 2011/65/EU

Note:

Please follow your regional recycling scheme for batteries and electronic waste Hereby, Shure Incorporated declares that the radio equipment is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity 2017/10/06

is available at the following internet address: http://www.shure.com/eu rope/compliance

Authorized European representative: Shure Europe GmbH Headquarters Europe, Middle East & Africa Department: EMEA Approval Jakob-Dieffenbacher-Str. 12 75031 Eppingen, Germany Phone: +49-7262-92 49 0 Fax: +49-7262-92 49 11 4 Email: [email protected]

MXWNCS2, MXWNCS4, MXWNCS8

Authorized under the FCC verification provision per Part 15b.

Industry Canada ICES-003 Compliance Label:

CAN ICES-3 (B)/NMB-3(B)

Note:

ings.

See the label located on the bottom side of the charger enclosure for the FCC marking, the CE marking, the RCM marking, and the electrical rat-

MXW1, MXW2, MXW6, MXW8, MXWAPT2, MXWAPT4, MXWAPT8

Certified under FCC Part 15.

FCC:

DD4MXW1, DD4MXW2, DD4MXW6, DD4MXW8, DD4MXWAPT4, DD4MXWAPT8.

Meets applicable requirements of RSS-213.

9/10

MXW Quick Setup

IC:

616A-MXW1, 616A-MXW2, 616A-MXW6, 616A-MXW8, 616A-MXWAPT4, 616A-MXWAPT8.

Trademarks

Audinate®, the Audinate logo and Dante are trademarks of Audinate Pty Ltd.

Shure Incorporated Shure Incorporated 5800 West Touhy Avenue Niles, IL 60714-4608 USA Phone: +1-847-600-2000 Email: [email protected]

10/10