Fanimation CW5 Instruction Sheet

Fanimation CW5 is a wall control that allows you to operate a ceiling fan with two fans but without a light. It has three fan speed settings, which you can select using the three slide switches on the control. The 3-speeds are low, medium, and high. The 0 slide switch turns the fan off.

To install the Fanimation CW5, you will need to disconnect the electrical power, remove the existing wall plate and switch, and make wiring connections with wire nuts. Once the wiring is complete, you can attach the wall control unit to the outlet box and restore electrical power.

Here are some possible use cases for the Fanimation CW5:

PDF

Document

CW5(C5) Wall Control
SPECIFICATION and INSTRUCTION SHEET
DESCRIPTION: Two Fan (no light) Only, 3 Speed-Slide Control
ELECTRICAL SPECS: 120 Volts, 60 Hertz, 5 amps, 3 Wire Installation
FAN MODELS USED: most Fanimation fans - see Catalog or visit our
website, www.fanimation.com for more information
How to Wire and Operate Your CW5(C5) Wall Control
NOTE: If fan or supply wires are different colors than indicated, have this unit installed by a qualified electrician.
GROUND
WHITE
BLACK
GREEN
WHITE
BLACK
WHITE
0
BLACK
3
2
1
GREEN
BLK (AC IN)
BLK (TO FAN)
GREEN/YELLOW(GROUND)
1. Installing Wall Control (Figures 1 &amp; 2):
• With electrical power still disconnected, remove the
existing wall plate and switch.
• Set the knob and light switch of the wall control in the
off (0) position.
• Make wiring connections with wire nuts as shown in
Figure 1.
– One black wire from wall control unit to black
(A.C. power supply).
– One black wire from wall control unit to black wire
leading to ceiling outlet box.
– One green/yellow wire from wall control unit to green
ground wire.
• Attach wall control unit to outlet box using the two
screws provided. Then, the face plate attaches the wall
control. (Figure 2)
• Restore electrical power.
120V AC SUPPLY
SOURCE
Figure 1
WARNING
To avoid possible ﬁre or shock, make sure that the electrical wires are completely inside the outlet box and not
pinched between the wall plate and the wall.
WARNING
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire connectors, except for the ground wire. Do not operate fan
until the blades is in place. Noise and fan damage could
result.
2. Operating &amp; Using Wall Control:
NOTE: Set pull chain to high speed before using wall
control. You can now use your speed control to select any
of the 3-speeds plus OFF.
• 3 Slide Switch – low fan speed
• 2 Slide Switch – medium fan speed
• 1 Slide Switch – high fan speed
• 0 Slide Switch – fan off
NOTE: Supply wires and fan wires
omitted for clarity.
10983 Bennett Parkway
Zionsville, IN 46077
(888) 567-2055 • FAX (866) 482-5215
Outside U.S. call (317) 733-4113
Visit Our Website @ www.fanimation.com
Figure 2
Copyright 2010 Fanimation
2010/01
">

Hello! I am an AI chatbot specifically trained to assist you with the Fanimation CW5 Instructions. I have thoroughly reviewed the document and can help you locate the exact information you need or explain the content in clear and simple terms. Whether you’re looking for guidance on specific features, troubleshooting steps, or general usage, feel free to ask your questions. The more details you provide about your concerns or needs, the more accurately and effectively I can assist you!