SW50
Remote Receiver
SPECIFICATION and INSTRUCTION SHEET
DESCRIPTION: One Ceiling Fan & Light, 3 Speed Remote Control
ELECTRICAL SPECS: 120 Volts, 60 Hertz, Fan 1.0 amp, Light Rating 2 5 0W Incandescent
or Halogen
FAN MODELS USED: Must use with TR20 Hand-Held Remote or the C21 Wall Control or Both
See Catalog or visit our website www.fanimation.com for more information
Be sure the electricity to the fan is turned off!
1. Removing the Switch Housing:
Remove the original switch housing from the fan
by unscrewing the three screws and unplugging the
connector (Figures 1 & 2).
2. Removing the Receiver Unit:
Carefully, slide the remote Receiver from the Switch
Cap Housing, and locate the code switches on the
underside of the receiver unit (Figure 3).
3. Setting the Receiver Code:
The remote unit has 16 different code combinations.
It may be necessary to test a couple frequency code
settings to improve signal reception and/or eliminate
interference from other remote control household items.
Multiple fans should have different code settings to allow
independent fan control. To set the code, slide code
switches to the same positions as is set on your C21 or
TR20 transmitter(s) (Figure 3).
3. Installing Receiver in Switch Cap Housing:
Slide remote Receiver into the Switch Cap, connect the
plug from the fan motor assembly into the socket located
in the receiver unit (Figure 3 & 4).
Figure 1
Figure 2
4. Installing the Switch Cap Housing:
Slide the assembled Switch Cap Housing over the
Swich Cap Base by installing and tightening the three
screws (Figure 5).
WARNING
Check to see that all connections are tight. To avoid
possible electrical shock, make sure that the electrical
wires are completely inside the switch housing and
not pinched between the switch cap base and switch
housing.
Figure 3
Figure 4
10983 Bennett Parkway
Zionsville, IN 46077
(888) 567-2055 • FAX (866) 482-5215
Outside U.S. call (317) 733-4113
Visit Our Website @ www.fanimation.com
Copyright 2013 Fanimation
2013/09
Figure 5
">
